Installation Guide - beautyrest Advanced Motion Base Manual Del Proprietário

installation guide

Always use two people when setting up the base.
STEP 1
Place the bed base box in a desired location with the top of
the box facing up.
Remove the binding straps and packing materials, making
sure not to puncture the box with any sharp objects.
STEP 2
Remove the bed base from the box keeping the bottom of the
base facing upwards.
STEP 3
To install Headboard Brackets, see instructions on page 15.
To install the legs, thread the washer over the screw on the leg.
Next, screw the leg into the nutsert on the frame. Do not over
tighten.
The 3-in-1 legs untwist into separate sections for custom leg
height options.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
8
STEP 4
To sync two bases see detailed installation
instructions on page 12.
Locate the Backup Battery Box and install (2) 9 Volt batteries
(not included).
STEP 5
Uncoil input Power Cord (connected to
Control Box's power port) and plug into
Power Supply.
STEP 6
Uncoil the Power Cord and connect to
the Power Supply. Place Power Supply
on the ground and extend from the base.
Ensure that the Power Supply and all
attached cords are directed toward the
desired surge protector.