Syncing Two Bases - beautyrest Advanced Motion Base Manual Del Proprietário

syncing two bases (optional)
A Sync Cord is included with the base. Not available on Queen, Full or Full-Long size bases.
The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
This process is most commonly used for syncing two connected TXL bases.
STEP 1
Unplug bases from power source.
STEP 2
Connect the Sync Cord to the Multifunction port of each Control
Box.
STEP 3
Plug bases back into the power source.
STEP 4
Check to ensure all cords are securely attached. Both remotes
will now operate both bases simultaneously.
The system is now linked. Pressed buttons on either remote
will control the two bases simultaneously.
12
Sync Cord
Control Box 1
PERFORMANCE NOTES
If bases become mismatched, returning the bases to the flat
positions will re-sync the mechanical positions.
Control Box 2