Maintenance And Care - Microson m4 mBTE-Open Fit Manual De Usuario

REMOVE: Turn the bend 180º and remove the bend from the hearing aid.
INSERT: Firmly insert the bend in the hearing aid, as indicated in the
illustration.

Check that the bend has been fully engaged in the hearing aid;
if not then the repeat the operation.
Change of Adapter

See Figure 12
REMOVAL OF ADAPTER: Hold the tube firmly and pull the adapter
until the two sections separate.
INSERTION OF THE ADAPTER: Hold the tube firmly and insert the
adapter until it is well placed.

Check that the adapter has been fully engaged in the fine tube.

Maintenance and Care


See Figure 13
DAILY
Cleaning the sound output of the cast/adapter. (Fig. 13.1)
Dehumidifier treatment. (Consult your hearing care professional)
WEEKLY
External cleaning of hearing aid (covering, bend, screws). (Fig. 13.2)
External cleaning of the cast/adapter. (Fig. 13.3)
Unclog the air vents of the cast. (Fig. 13.4)
Cleaning the battery compartment. (Fig. 13.5)
Auditory tube review (stiffness, cracking or color change)
EN
20
Solution to Possible Problems
SYMPTOM
POSSIBLE
CAUSE
Weak battery
The hearing aid
Ineffective hearing
is not functioning
Not enough Covered or clogged
volume cast/adapter
Distorted
or unclear Wasted battery
sound
Manufacturer's customer service:
NOTE
Contact your hearing care professional or distributor about any other
problem or doubt.
Accessories and spare parts
94582 Microson 312 M/Free Hearing Aid Battery
99535 Microbox ONE Microson Case
91118 Brush Cleaner
99467 Microson Wipe
99582 m2 mBTE Open Fit/m4 mBTE Open Fit User's Manual
21
SOLUTION
Replace battery
Consult your specialist
aid
Eliminate the
obstruction and clean
the cast/adapter
Replace battery
+34 93 300 58 00
helpdesk@microson.es
EN