Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
through entirely.
(See point 5, Slot cut adjustments see point 5.3.3)
Now turn on the laser (ON/OFF Switch at battery box) and check if the laser beam marks exactly
the real cutting line.
If not you need to adjust the whole laser assembly until laser indication matches exactly the ac-
tual cutting line.
13.2
OPERATION
13.2.1 Switch on & prepare to cut
Connect the machine to the power supply
Read, understand and apply the security instructions.
Put ON/OFF switch (3) lever and wait until the saw blade has reached its full speed.
With the forefinger you now push the security lock lever to the left to unlock the moveable
saw blade protection (6).
13.2.2 Switch off
As soon as you release the accelerator knob , the motor stops and the saw blade stops within 5-8
seconds.
13.3
Operation modes
All adjustment activities only when machine is switched off and dis-
connected from power supply!
13.3.1 Miter cuts
Ideal for cutting short workpieces in miter and/or bevel angles.
For miter cuts fix the saw arm on the sliding bars with fixing knob (29).
Place the material to the back fence and fix the material additionaly with the downholder
(19).
Prepare to cut according to 5.1, perform the cutting operation.
Swing the saw arm back up, release the accelerator lever and wait until the electric saw
brake stops the saw.
Now you can take the workpiece away
13.3.2 Sliding cuts
Sliding cuts are ideal for performing longer cuts
Fix the material!
Pull the saw towards your body.
Switch the machine on, wait until saw blade reaches full speed.
Now swing the saw arm down and let it work its way slowly through the material. Now push
the saw arm slowly backwards.
Advantage: If the material cracks or material parts are catapulted, then not towards the op-
erator.
HOLZMANN Maschinen GmbH
www.holzmann-maschinen.at
Zug-, Kapp-, Gehrungssäge / Profi mitre saw / Manual de instrucciones/Mode d´emploi
OPERATION
Seite 35
KAP 255 XJL
Publicidad
Tabla de contenido
