Sears Kenmore 15831 Manual De Uso Y Cuidado página 16

:iii!ijj,!i o iiJii :iii:!+i+li ii i:ii!i!!+i ii:++i,, iiii ¸ ¸,
Start Button Memory
+ To use last full cycle and options completed, press the
Start pad.
® If you do not run dishwasher daily, close door to main-
tain memory.
® If power is off or door is open for an extended period of
time, the Start button memory will default to Normal
cycle with Heat Dry.
To change a cycle
® Press Cancel+Drain. Wait for 2-minute drain to com-
plete, Reset dishwasher for desired cycle and options.
(Remember to add detergent if dishwasher has already
gone through wash portion of original cycle.)
OR
® You can change cycle and options any time during first
2 minutes of cycle (while water is entering dishwasher
without pressing Cancel+Drain.
To cance_ a cycle
+ Press Cancel+Drain. Wait for 2-minute drain to complete.
Control Lock
+ Prevent accidental cycle selections by "locking" controls.
®To lock controls: Press and hold No Heat Dry pad for
4 seconds. Control Lock status indicator glows when
controls are locked.
®To unlock controls: Press and hold No Heat Dry pad for
4 seconds. Control Lock status indicator will flash and
turn off.
+ If you try to set cycles or options when controls are
locked, Control Lock status indicator will flash so you
know cycles or options cannot be selected until controls
are unlocked.
Refer to the "troubleshooting Guide" section for special cleaning problems.
Cleaning the exterior
In most cases, regular use of a soft, damp cloth or sponge
C_eaning the interior
Hard water minerals may cause a white film to build up on
the inside surfaces, especially just beneath the door area.
To clean interior:
+ Apply powdered dishwasher detergent to a damp
sponge to make a paste.
OR
+ Use liquid automatic dishwasher detergent and clean
with damp sponge _.
Do not clean the dishwasher interior until it has cooled.
Wear rubber gloves. [)o not use any type of cleanser
other than dishwasher detergent because it may cause
foaming or sudsing.
15