Team Electronic TeCom-X5 Instrucciones De Uso página 13

English
21 STE
Side Tone Eliminate - On / Off
Under certain circumstances, a clicking sound can be heard upon releasing the PTT key. The
function STE reduces this noise, which is useful when the radio is operated with a headset.
22 TOT
Time-Out-Timer - Off / MIN 1 - 7
Restricts transmission time to set time period (1 - 7 minutes). After expiration of set time limit,
transmission is aborted. For reset, release PTT key.
23 TXSTOP
transmission blockage - ON / OFF
24 VOX
voice operated signal transmission - On / Off
VOX allows hand-free operation. Transmission starts automatically once the signal strength rea-
ches a certain level.
25 VOX D
VOX delay
determines how long the VOX function will be still active after the signal stopped.
settings: 15 / 25 / 35 / 45
15 : 1 second 25 : 2 seconds
26 VOX S
VOX sensitivity
settings: level 1 - 8;
level 1 = most sensitive, i.e. transmission starts easily after a low signal
level 8 = least sensitive, i.e. signal has to be very strong for the transmission to start
27 VXB
VOX lockout on busy channels - On / Off
28 WIDNAR
bandwidth - not available
The bandwidth can only be set via software.
24
35 : 3 seconds 45 : 4 seconds
5-TON SELECTIVE CALLING
The TeCom-X5 contains a 5 tone selective calling function, which parameters are set via soft-
ware. To send a 5-tone decode, press the programmable function key (10) and enter the 5-tone
encode via keypad. Then, press the PTT key (9) to send your message.
General Description:
Each radio is programmed with an individual radio ID (5-Tone ID). This ID code, which serves
also as a decode, is always sent with the encode.
The 5-Tone encodes are entered via keypad. This way, all possible encodes can be sent without
memory storage restrictions.
The own ID is always sent with the encode. If the sent 5-tone encode matches the ID code of
the other radio, the sent ID code will be displayed by the receiving radio and the radio reacts in
the programmed way, e.g. the speaker unmutes, a beep tone is audible or an automatic ack-
nowledgement is sent.
Important: For the selective calling function to work, the programmable function key (10) has to
be set to Optional Signal Call.
For more information on how to program the 5-tone function, read the T-UP15 software manual.
CONNECTOR
The TeCom-X5 has a Kenwood-compatible accessory jack (3.5 / 2.5 mm - stereo / stereo) for
connecting headphones, microphones and the data transfer cable, required for programming the
radio via software.
Suitable accessory can be found in the actual TEAM catalogue.
English
25