AUtec Modular Serie Manual De Usuario página 22

LIMKDPU0
Industrial radio remote controls with
data deedback operations are used for
the control of machines from a distance
and for receiving and viewing
information and/or signalling regarding
the machine.
Each industrial radio remote control of this type is made up of three units:
- a transceiving unit MK10 DF portable,
- a receiving unit and a transmitting unit called DATAFEEDBACK TRANSMITTER
installed on-board of the radio remote controlled machine.
From the transceiving unit the operator can control the machine from a distance and also
receive information and signalling from it.
The transceiving unit uses radio frequencies to transmit a coded message which contains a
value called address. Each receiving unit can only decode the messages coming from a
transmitting unit with the same address.
This excludes the possibility of an interference activating any system function. If the radio
frequency transmission is disturbed, incorrect or interrupted, the receiving unit
autonomously stops the whole system.
The DATAFEEDBACK TRANSMITTER transmitting unit sends signalling messages using a
protocol that can be set by dip switches (refer to paragraph 9 "Programming").
with the R&TTE 99/05/CE Directive and all its essential requisites.
Each radio remote control is also in conformity with the norms
given in the EC conformity declaration present in this manual.
!
Autec cannot be held responsible if the radio remote control is
installed on applications that are different from those permitted
Material lifting machines (construction cranes, industrial bridge cranes,
machines for moving material in general, . . . )
Machines installed in areas where equipment with explosion-proof
characteristics are being used.
Machines for moving, raising and transporting people.
INTRODUCTION
Each radio remote control is in conformity
PERMITTED USES
FORBIDDEN USES
2
Receiving
unit
Transmitting
unit
DATA
FEEDBACK
machinery
TRANSMITTER
.
commands
Transceiving
information
unit
and/or signalling
:
Page 2