AUtec Modular Serie Manual De Usuario página 33

LIMKDPU0
!
Some European countries only permit the use of this radio apparatus
in the 434.040-434.790 MHz band, therefore user country limitations
must be verified.
The use of 433.050-434.790 MHz band frequencies has not yet been
harmonised in Europe: check for possible user's country limitations.
The radio frequency of AUTEC radio remote controls is included in the group of
frequencies permitted by those European regulations that are current at the
moment of radio remote control entry onto the market.
With this type of radio remote control:
- the radio link between the MK10 DF transceiving unit and the DATAFEEDBACK
TRANSMITTER transmitting unit can ONLY operate in the MANUAL selection mode.
- the radio link between the MK10 DF transceiving unit and the receiving unit can operate
in the AUTOMATIC scan mode (producer's standard programming) or in the MANUAL
selection mode.
When operating in the MANUAL selection mode it is possible to work at a specific
frequency that must be set manually by programming the dip switches in the radio
modules (see paragraph 9 "Programming").
To set or modify this operation mode contact personnel that have been authorised
by Autec.
When operating in the AUTOMATIC scan mode it is possible to operate at a specific
frequency, which can be changed in case of interference or conflict with other radio
equipment using the "Changing the operating frequency" procedure.
This mode avoids internal interventions on the transceiving unit and the receiving unit.
1
With the transmitting unit started (blinking green LED):
- press the START pushbutton and keep it pressed,
- press the STOP pushbutton,
- release the START pushbutton.
2
Unlock the STOP pushbutton by
turning it as shown in the photo and
repeat the starting procedure.
N.B.: During the work frequency changing process, the receiving unit loses radioelectric
connection with the transmitting unit. After starting, some seconds may be necessary to
reset connection, therefore keep the START button pressed for about 8-10
seconds.
8
FREQUENCIES
MANUAL SELECTION MODE
AUTOMATIC SCAN MODE
Working frequency change process
Page 13