HAEGER GC-02E.001A Instrucciones De Uso página 7

Connecting the Gas cylinder to the gas stove
 This appliance is only suitable for use with low-pressure butane or propane gas, fitted
with the appropriate low-pressure regulator via a flexible hose. The hose should be safely
secured to the regulator and the appliance (with hose clips).
 The regulator should comply with the EN 12864 standard.
 The appliance was set to be connected with a flexible hose and having a length not
exceeding 150 cm.
 The hose should comply with the EN 1763-1 standard.
 Be sure that after connecting the hose it is not creased or is in contact or near the hot
zones. Whether the tube or the regulator/reducing gas pressure should be certified and
marked in accordance with applicable standards. The fixing of the pipe to the unit and
the gearbox must be done by clamps.
 For a better fixation it is recommended that first heats the tube dipping it for one minute
in hot water.
 After the connections, check the leakage of the whole gas circuit retaining the ignition buttons off and the bottle
reducing gas pressure knob open, and then applying a mixture of water and soap. The blistering means that
there is gas leakage.
Warning: Accessible parts may be very hot. Keep young children away from the hot appliance at all
times (even while cooling down!).
5
English