Utilisation - Parkside KH 4125 Instrucciones De Uso

Insert the spindle shaft of the electric drill
Now slide the pump
pump extends into the drill chuck, and the pegs of the mounting
inserted into the receptor holes on the pump
Through the recess
the pump cannot be detached from the mounting.
Securely tighten the cross-head screw on the mounting
is being firmly held .
Connect the suction hose to connection
u
connection

Utilisation

Insert the open end of the suction hose into the fluid to be drained/
transferred. Suction is only possible if ...
– the suction hose does not draw air and is not longer than 12 meters
(ca. 39 feet), and
– the pressure hose is open during suction.
Now allow the electric drill to drive the pump – but not without super-
vision, so as to be able to react quickly in the event of danger. Make
absolutely sure that the drill revolves to the right, just as in drilling. Should
the drill-speeds be adjustable, you can adjust the work capacity with
them.
q
onto the mounting
t
, turn the drill chuck with the chuck key so tight that
.
r
into the mounting
e
so that the drive axle of the
q
.
y
and the pressure hose to
- 20 -
e
.
e
are
e
so that the drill