CRB Industries TM4 Instrucciones De Uso página 19

CRB INDUSTRIES manufacturing
CARPET CLEANING MACHINE TM4 / TM5 Instructions manual
How To Properly Clean With The CRB System
(Restorative & Maintenance)
Step 1:
Ensure that you have a high grade commercial vacuum cleaner to suck up any loose dust and surface
dirt/particles.
Step 2:
Attach the renovators that come with the machine and go over the same area where you just vacuumed. Due to
the counter rotating brush action, your machine will dig deep down into the carpets to restore the pile and pull up
human and pet hair and any other debris that a standard vacuum cleaner is unable to recover.
Step 3:
If you have purchased the CRB machine to use as an agitator and pile lifter for HWE please skip to read Step 3A.
Step 3A:
Treat spots with CRB Industries 3 in 1 Enzyme Carpet Cleaner at full strength. Pre - spray heavily soiled areas
with Enzyme Carpet Cleaner diluted at 16 oz. per gallon. Then dilute the Enzyme Carpet Cleaner at 2-3 oz. per
gallon (16 ml/litre) of water for extraction equipment. If necessary, a defoamer may be added to the recovery tank
to control excess foam from high foam shampoo residues.
Step 4:
Once you have recovered the debris with the renovators attached, remove them and attach the dust covers. See
below for the chemistry dilution and proper agitation for restorative and maintenance cleaning.
Restorative/Deep Cleaning
Step 1:
First mix 1 gallon of water with 32 ounces of concentrate of the Ultra Pro Peroxide Encapsulation & Pre-Spray for
spot cleaning. This will be applied to only the heavy soiled spot and stains. Next dilute another gallon of water
with 12-16 ounces of concentrate of the Ultra Pro Peroxide Encapsulation & Pre-Spray and spray the whole
carpet. Let it dwell for 1-5 minutes. If you are in a residential area use the grey brushes, for commercial use the
blue and/or green brushes and agitate in all directions N,S,E,W,NE,NW,SE,SW. You can also use our RTU
Enzyme Spotter if you do not want to dilute the 32 ounces. Apply the spotter to the area twice the size as the
stain and then encap the rest of the carpet as described above.
Step 2:
Once the agitation has been completed, remove the dust covers and attach the renovators. Begin to recover the
encapsulated soil and finish with another vacuum run for superior cleaning results.
18