Ecler NUO5 Manual De Instrucciones página 14

Selector push button FX CUE (30)
Push the FX CUE selector to monitorize the effect.
The CUE signal is affected by DRY-WET crossfader (25).
The effect processor is continuously working for the cueing: the EFFECT activation does not affect the FX CUE.
In order to properly "CUE" the effect processor, the FX SEND (10) signal is Pre-fader by default. Once monitorized
and adjusted the effect parameters, keep the EFFECT selector activated and switch ON the FX LAUNCH (23)
button: the effect processing will automatically change to Post-fader, which means the effect mix is controlled by
the channel fader.
Rotary/Push control TIME (31)
Control the effect beat synchronization.
The value shown on the led display is a "Beat" fraction: "1.50" means "1 beat and a half" time value.
Low Pass Filter, High Pass Filter and Pitch Shifter are "manual" effects and are not affected by the TIME control.
Under Vocoder effect, TIME controls the carrier synthesis note.
Ex. with Delay effect: if the led display shows a "2.00" value, it means the processed signal is delayed 2 beats from
original input signal. "1-2" means ½ beat.
Oscillated effects L.F.O. Filter, Flanger and Phaser are synchronized in beat-patterns where 1x beat-pattern
= 1x beat.
The push function of the control TIME recalls TIME "Synchronization References". You have 4 references (4
pushes) per effect.
Ex. with Delay effect :
1st push automatically sets a REF. Delay Time of "1-4" (1/4 beat Delay)
2nd push automatically sets a REF. Delay Time of "1-2" (1/2 beat Delay)
3rd push automatically sets a REF. Delay Time of "3-4" (3/4 beat Delay)
4th push automatically sets a REF. Delay Time of "1.00" (1 beat Delay)
5th push comes back to 1st REF. value.
Rotary/Push control PARAMETER (27)
Control one main parameter of the selected effect. The rotary control adjusts a different parameter type for each
effect: please refer to the effect description.
The push function of the control PARAMETER is a "TAP function". The "TAP function" allows to enter manually a
beat sequence in the synchronization system. You have to push 3 times to enter a beat sequence, then the system
will briefly display the Beat Per Minute value calculated from the push sequence (around 3 seconds).
Effect mix crossfader DRY-WET (25)
The DRY-WET crossfader allows you to blend the processed signal (called WET) with the original input signal
(called DRY).
14