Pc Mode - Effect Remote Parametering; Drivers And Software Installation - Ecler NUO5 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. PC MODE – EFFECT REMOTE PARAMETERING
The NUO5 is world's first programmable effect dj mixer.
The NUO5 internal effects we previously described can be edited and reparametered on a PC program via
Universal Serial Bus: the edi:lab software.
The edi:lab software requires Windows 98SE, ME, 2000 or XP.

7.1 Drivers and Software installation

An installation CD-rom as well as a USB cable is provided with the NUO5 mixer.
Before installing the hardware drivers and edi:lab software:
Switch ON the NUO5 mixer.
Press the PARAMETER Control of the NUO5 for 5 seconds. The led display shows "PC": you are in "PC Mode".
Connect the USB cable between the NUO5 mixer and your PC (Computer USB Port).
Switch ON the computer.
Hardware driver installation
When you connect for the first time the USB cable coming from the NUO5 mixer to your PC, the computer will
detect a new hardware device and request its driver installation. The driver is simply a "software link" between the
computer Operation System, the application software (the edi:lab in our case) and the communication port device
of the hardware.
Install the USB drivers from the installation CD-Rom provided with the mixer.
Edi:lab software installation
Once you have installed the USB drivers on your PC you can start installing the edi:lab program running
"setup.exe" from the CD-ROM.
21

Publicidad

Tabla de contenido
loading

Tabla de contenido