Receiving a station through a list
— LIST
You can list up the frequency or the name. For
details on labelling a station, see page 10.
(With the card remote commander)
1
Select the band, then press (LIST).
The frequency or station appears.
2
Press M or m repeatedly until the
desired station appears.
3
Press (ENTER) to receive the station.
Other functions
Changing the sound settings
Adjusting the sound
characteristics
You can adjust the bass, treble, balance, fader
and subwoofer volume.
1
Select a source, then press (SOUND)
repeatedly to select the desired item.
The item changes as follows:
BAS (bass) t TRE (treble) t
BAL (left-right) t FAD (front-rear) t
SUBW (subwoofer volume)*
* "ATT" is displayed at the lowest setting, and can
be adjusted up to 20 steps.
2
Press the volume +/– button
repeatedly to adjust the selected item.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Note
Adjust within 3 seconds of selecting the item.
With the card remote commander
In step 2, to adjust the selected item, press < or ,.
Adjusting the equalizer curve
— EQ7 Tune
You can adjust and store the equalizer settings
for different tone ranges.
(With the card remote commander)
1
Select a source, then press (MENU).
2
Press M or m repeatedly until "EQ7
Tune" appears, then press (ENTER).
3
Press < or , repeatedly to select
the desired equalizer type, then press
(ENTER).
4
Press < or , repeatedly to select
the desired frequency.
The frequency changes as follows:
62Hz y 157Hz y 396Hz y 1kHz y
2.5kHz y 6.3kHz y 16kHz
continue to next page t
9