Kenmore 363 Manual De Uso Y Cuidado página 13

ADJUSTABLE SHELVES
Shelf supports at various levels enable you to reposition
the shelves from time to time to better accommodate
your variable inventory of refrigerated foods°
HALF-WIDTH SHELVES
(on some models)
One end rests on a
molded side-wall support;
a bracket on the other
end hooks into a track
on the rear cabinet wall
To remove, lift the shelf up at
front, then off the support
and out of the track,
To replace, select desired
shelf height° With shelf front
raised slightly, hook the
bracket's top lug into the
track, then lower the sheff
onto the support.
Tempered glass shelves
(on models so equipped) are
adjustable in the same
manner,
NOTE: The shelf to the right
of the track is designed to
hook into the right-hand slot;
the shelf to the left is designed
to hook into the left-hand sloto
FULL-WIDTH SHELVES
(on some models)
Some models have a
steel wire sliding shelf, a
stationary tempered glass
shelf or two steel wire
stationary shelveso These
shelves can be relocated
elsewhere in the fresh food
compartmenL
The full-width sliding shelf
has stopqocks. When placed
correctly on the shelf
supports, the shelf will stop
before coming completely out
of the refrigerator and will not
tilt when you place food on it
or remove food from it.
To remove any full-width shelf, lift
the rear of the shelf and pull forward,
To remove a full-width
shelf when the fresh
food compartment
door cannot be opened
fully, lift the rear of the
shelf, pull forward and
down, tilt the sheff and
take it out.
13