Kenmore 363 Manual De Uso Y Cuidado página 21

REHANGING THE FRESH FOOD DOOR
a. Lower the bottom socket
of the fresh food door onto
the pin on the bottom hinge°
Be sure the washer is in
place on the pin.
b. Insert the pin on the center
hinge into the socket in the
top of the door. NOTE: The
center hinge must be
turned over as shown when
mounted on the left side.
Washer
¢. Tilt the door toward the
cabinetr As the door is
brought into position, slide
the hinge under the head of
the screw which earlier had
been partly driven into the
outermost hote_ insert the
remaining screw, then
tighten both screws
securely.
Plastic
Washer
REHANGING THE FREEZER DOOR
a_
b_
c_
Lower the bottom socket
of the freezer door onto the •
center h{nge p|n_ Be sure _ Hinge Pin
the washer is in place on
the pin.
Tllt the door toward the
cabinet, lifting the top hinge
so the pin fits into the
socket on top of the door. Plastic
Before tightening the top hinge screws, make sure the
top of the door is level with the cabinet top and the
space between the doors is equal across the entire
front° Do not overtighten these screws--tighten them
unti! they are just snug, then turn them in another
one-half turn.
EXAMINING THE DOOR GASKETS
Check the door gaskets al! around, making sure no gaps
are visible between the gaskets and the cabinet. If a gap
shows, try stretching the gasket away from the door so
the magnet in the gasket will contact the cabinet surface,
being careful not to dislodge the gasket,
21