Ecler DP 300 Manual De Instrucciones página 11

PARAMETER
Input Delay
Input EQ type
Input EQ frequency
Input EQ gain (+/-)
Output Name
Output Source
Output Gain
Output Limiter
Output Delay
Output Delay link
Output Polarity
Output bass curve
Output bass frequency
Output treble curve
Output treble frequency
Output EQ type
Output EQ frequency
Output EQ gain (+/-)
Output EQ width
MONO mode
In mono mode, the processor is configured as follows:
All outputs (1-6) are connected to input CH1 (A).
-
Crossover frequencies are set up to cover the entire audio frequency range. (Full range
-
operation).
The default Delay link is set to OFF.
-
No stereo linking is allowed.
-
The names of the outputs are set to "Band 1" to "Band 6" for Outputs "OUT 1" to "OUT6"
-
respectively.
LINK MODE
Offset
Step
Offset
Offset
Offset
Offset
Offset
Offset
Offset
Offset
Step
Step
Offset
Step
Offset
Step
Offset
Offset
Offset
2X3 WAYS
A(CH1)-B(CH2)
A(CH1)-B(CH2)
A(CH1)-B(CH2)
A(CH1)-B(CH2)
1-2, 3-4, 5-6
A(1,3&5) & B(2,4&6)
1-2, 3-4, 5-6
1-2, 3-4, 5-6
1-3, 3-5, 2-4, 4-6
1-3, 3-5, 2-4, 4-6
1-2, 3-4, 5-6
1-2, 3-4, 5-6
1-2, 3-4, 5-6
1-2, 3-4, 5-6
1-2, 3-4, 5-6
1-2, 3-4, 5-6
1-2, 3-4, 5-6
1-2, 3-4, 5-6
1-2, 3-4, 5-6
3X2 WAYS (LCR 2WAY)
A(CH1)-B(CH2)
A(CH1)-B(CH2)
A(CH1)-B(CH2)
A(CH1)-B(CH2)
1-3, 4-6
A(1&4)/B(2&6)/A+B(3&5)
1-3, 4-6
1-3, 4-6
1-4, 2-5, 3-6
1-4, 2-5, 3-6
1-3, 4-6
1-3, 4-6
1-3, 4-6
1-3, 4-6
1-3, 4-6
1-3, 4-6
1-3, 4-6
1-3, 4-6
1-3, 4-6
11