Ecler DP 300 Manual De Instrucciones página 34

Chose the 3 way mode and press the ENTER key to confirm the selection.
Change to 3 way?
Enter to confirm
The screen will change according to the new 2 channel 3 way mode.
SETUP
CONFIG 2ch 3 way
In this example, it would be wise to activate the Stereo Link option between channels, although it is not
indispensable. If no stereo linking is specified, all parameters must be configured channel by channel,
otherwise only one of the channel pairs must be set up. In this example it is recommended to activate
the stereo link (Stereo Link = On). Press the NEXT key and following screen appears.
SETUP
Stereo Link
Once the operation mode has been selected, let's now configure the inputs.
Press the encoder to access the Input INA & INB. Press the PREVIOUS and NEXT keys to access the
individual input configuration parameters.
The first screen refers to the delay. Leave this setting at 0,000 ms (no delay)
IN A & IN B
Delay
Next come the screens referring to the input equalizer. Given the circumstance that no input EQ is
needed in this case, these screens will be abandoned to configure the outputs next.
Press the encoder wheel twice gives access to the configuration of the linked outputs OUT1&2. These
two outputs are used to drive the low-frequency way of the speaker system.
Following screen will appear by default.
OUT 1&2
Name
For clarity, it is advisable to change the name of this output pair for clarity to "Low". Turn the encoder or
use the ◄ and ► keys to select this name.
OUT 1&2
Name
34
ON
0.000ms
Band 1
Band 1
Low
Low