Adjusting the sound
characteristics
You can adjust the bass, treble, balance and
fader.
Each source can store the bass and treble levels
respectively.
1
Select the item you want to adjust by
pressing (SOUND) repeatedly.
VOL (volume) n BAS (bass) n
TRE (treble) n BAL (left–right) n
FAD (front–rear)
2
Adjust the selected item by rotating the
dial.
Adjust within three seconds after selecting
the item. (After three seconds, the dial
functions work as the volume control.)
EN
Attenuating the sound
Press (ATT) on the optional rotary
commander.
"ATT-ON" flashes momentarily.
To restore the previous volume level, press
(ATT) again.
Tip
The unit decreases the volume automatically when
a telephone call comes in (Telephone-ATT
function).
20
Changing the sound and
display settings
You can set:
•CLOCK (page 6).
• CT (Clock Time) (page 18).
• DIM to change the brightness of the display.
—Select "AUTO" to dim the display only
when you turn the lights on.
—Select "ON" to dim the display.
• BEEP to turn on or off the beeps.
• RM (Rotary Remote) to change the operative
direction of the controls of the rotary remote.
—Select "NORM" to use the rotary remote in
the factory-set position.
—Select "REV" when you mount the rotary
remote on the right side of the steering
column.
1
Press (SHIFT).
2
Press (8) (SET UP) repeatedly until the
desired item appears.
Each time you press (8) (SET UP), the item
changes as follows:
CLOCK n CT n DIM n BEEP n RM
Note
The displayed item will differ depending on
the source.
3
Press (10) (n) to select the desired
setting (for example: ON or OFF).
4
Press (SHIFT).
After the mode setting is complete, the
display goes back to normal playback
mode.