Safety Instructions; Initial Operation - Gardena 1490 Manual De Instrucciones

2. Safety Instructions

Unplug the drill before assembly / disassembly.
The drill may only be used with an FI switch.
Check the drill and pump for damage before use. A damaged drill or pump
may not be used.
Keep people away from the area in which the appliance is being used.
The pump may only be used under supervision.
Work on dry ground only.
Unplug the drill immediately if water is leaking or has leaked from the pump.
Unplug the drill when it is not in use / you leave the drill unintended.
Do not disassemble the pump (do not remove screws).

3. Initial Operation

Assembling the pump :
DANGER ! Physical injury !
V Make sure that the pump and drill cannot twist, wobble
or tilt.
1. Unplug the drill.
2. Make sure that the tap connectors are airtight when tightened on the inlet
and outlet side.
3. Fit the pump drive shaft (8 mm ∅) into the drill chuck.
4. Secure the pump and drill in position.
Connecting the suction and pressure hose :
DANGER ! Electric shock !
Electric shock if water leaks into the drill !
V Make sure that the hoses are secured against slipping.
The hoses must be made from pressure-resistant material (fabric-reinforced
hose, e.g. GARDENA Classic or FLEX Hose). The suction hose should not be
more than 3 m long.
1. Make sure that the suction and pressure hose is leak proof
(e.g. with GARDENA Hose Connectors).
2. Insert the suction hose onto the inlet side and the pressure hose onto the
outlet side of the pump (see white arrows indicating the direction of flow).
10