During Washing; Changing A Program; Add A Garment / Interrupting The Program; Canceling Active Program - Bosch Nexxt 300 Serie Manual De Instrucciones

During Washing
[_Due to the highly engineered
suspension of this appliance, it
may experience a shudder or
shake when progressing from
lower to higher spin speeds.
This behavior is normal due to
shifting of the drum system and
should not cause concern.
Changing a program
Turn the program selector to Off.
Turn the program selector to a
newly selected program.
The Start/Pause indicator light
flashes.
If required, change the settings;
see from Page 16.
Press the Start/Pause button.
The program starts.
The indicator light is lit.
Add a garment /
Interrupting the program
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the program at
any time.
[_lt is not recommended to add
laundry after the washing phase is
complete.
[_You can add or reduce laundry as
long as the Start/Pause indicator
light flashes (red).
Press the Start/Pause button.
The Start/Pause indicator light
flashes.
Open the door.
Place/remove the laundry.
Close the door.
Press the Start/Pause button.
The program continues.
The indicator light is lit (red).
When the Start/Pause indicator
light is lit (red), the program can be
interrupted, however the door
cannot be opened for safety
reasons (water level, temperature
or speed too high).
If the spin speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
"Pause" mode when the drum is at
a standstill.
Canceling an active
program
If you would like to terminate a program
and remove the laundry:
If a program is interrupted at a high
temperature, leave the laundry to
cool down until the glass is cool to
touch.
Turn the program selector to Off.
Turn the program selector to Drain
or Spin.
For Spin, select the desired spin
speed (but not no final spin).
Press the Start/Pause button.
Wait until this program ends.
Open the door.
Unload the laundry.
If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
If the program is terminated by
switching off the appliance, the
door may remain locked.
After Washing
The Start/Pause indicator light goes
out.
e:ee appears in the display.
Open the door.
O
Permanent press U Regu!ar/Cotton
T
Drain
Turn the program selector to Off.
L.I CIose the taps.
Remove the laundry.
If "No final spin" preselected
The Start/Pause indicator light flashes.
Turn the program selector to
Drain. The Start/Pause indicator
light flashes.
Press the Start/Pause button.
The indicator light is lit.
When this program has ended,
open the door.
Turn the program selector to Off.
Close the taps.
Remove the laundry.
After washing, leave the loading
door ajar to allow the inside of
the washing machine to dry.
18