TCE 20030 Manual Del Propietário página 16

LUBRICATION
A periodic coating of light lubricating oil to pivot points will help to ensure that pump pistons move freely.
Note: Never apply oil to the saddle. If saddle extension threads require lubrication; clean thread surfaces with
a clean, dry cloth, then apply a drop of bearing grease to the threads. Distribute as evenly as possible along
the threaded post.
TROUBLESHOOTING
RAM RAM BLEEDS
WILL NOT OFF AFTER
PRESS PRESS
LOAD OPERATION
X X
X
X X
X
X
Safe Operating Temperature is between 40°F – 105°F (4°C - 41°C)
Clean
RAM WILL NOT
RETRACT POOR LIFT
AFTER PERFORMANCE
UNLOADING
X
X
RAM WILL
NOT EXTEND
TO FULL
EXTENSION
X
X
X
X
X X
16
CAUSES AND SOLUTIONS
Release valve not tightly closed.
Ensure release valve tightly closed.
Overload condition.
Remedy overload condition.
Power unit malfunctioning.
Replace the power unit.
Reservoir overfilled.
Remove pump, then drain fluid to
proper level.
Linkage binding.
Clean and lubricate moving parts.
Fluid level low.
Ensure proper fluid level.
Air trapped in system.
Purge air from system.
Full
retracted