Important; Tool Use And Care; Features - Surtek LE612 Manual De Usuario

specified voltage may cause a serious injury to
the user as well as damage the tool.
IMPORTANT: This appliance is not intended
for use by persons (including children) with re-
duced physical, sensory or mental capabilities
may be different or reduced, or lack of experi-
ence or knowledge, unless such persons are su-
pervised or trained to operate the product by
a person responsible for their safety. Children
should be supervised to ensure they do not use
the devices as toys.

TOOL USE AND CARE

Do not force the power tool. Use the correct
tool for the application. The correct tool will
do the job better and more safely at the rate
that it was designed to work at.
Do not use tools if switch does not turn it on
or off. Any tool that cannot be controlled with
the switch is dangerous and must be repaired.
Disconnect the plug from the power source
before making any adjustments, changing ac-
cessories or storing the tool. This preventive
safety measures reduce the risk of accidental
starting of the tool.
When the power tool is not in use, store it out
of the reach of children, and do not allow in-
dividuals who are not familiar with the power
tool or these instructions to operate it. Power
tools are dangerous in the hands on untrained
users.
Maintain the power tool. Check for misalign-
ment or binding of moving parts, broken parts,
and any other condition that may affect the
operation of the power tool. If it is damaged,
have it repaired before using. Many accidents
are caused by poorly maintained power tools.
Check for misalignment or bonding of moving
parts, breakage parts, and any other condition
that may affect the tools operation. If you find
a damaged tool, take it to service before use it.
Use only accessories that are recommended by
the manufacturer of your model. Suitable ac-
cessories for one tool, may become hazardous
when are used on another tool.
Keep cutting tools, sharpened and clean. Cut-
ting tools in good condition with sharpened
edges, are less likely to stuck in workpieces or
easier to control.
E N G L I S H •
Is recommendable to use a safety device suit-
able, such a thermal and differential switch
when you are using an electric equipment.
SERVICE
Tool service must be performed only by quali-
fied repair personnel. Service or maintenance
performed by unqualified personnel could re-
sult in a risk of injury.
SPECIFIC SAFETY RULES FOR
BELT-DISC SANDERS
1. ALWAYS wear ear protectors/defenders
when using this machine.
2. ALWAYS wear a dust mask when using this
machine. Be aware that harmful or toxic dusts
could be produced when sanding some woods.
3. ALWAYS use the table to support the work-
piece.
4. ALWAYS check to ensure the table and at-
tachments are secure before starting.
5. ALWAYS maintain a clearance of 2 - 3 mm
between table and sanding disc.
6. ALWAYS hold the workpiece firmly so that it
cannot be torn from your hands.
7. ALWAYS feed the workpiece against the
direction of rotation of the disc, i.e. the LEFT
side of the disc.
8. ALWAYS keep the mains cable well away
from the machine and ensure an adequate
electrical supply is close at hand so that the
operation is not restricted by the length of the
cable.
9. ALWAYS use a dust extraction device, prop-
erly connected to the dust extraction port.
10. ALWAYS ensure that nails or foreign ob-
jects have been removed from a workpiece
beforehand. Nails etc. will destroy the belt or
disc.
11. NEVER allow the ventilation slots in the
motor to become blocked.
12. NEVER sand pieces which cannot be held
firmly by hand.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
U se r' s m a nu a l
11