Pioneer A-209 Manual De Instrucciones página 7

STEREO AMPLIFIER
POWER
— _
OFF ON
SPEAKERS BASS
PHONES
–
~
6
DIRECT button/indicator
Use this button when you do not wish to pass the output from
input terminal equipment through the various frequency ad-
justing circuits (BASS, TREBLE, BALANCE, LOUDNESS).
On : The indicator lights: The signals passing through the
input terminals are reproduced without passing through
the various frequency adjusting circuits. This results in
flat, pure sound which is a more faithful reproduction of
the input source.
Off : The indicator goes off: The signal passes through the
various frequency adjusting circuits.
7
LOUDNESS button/indicator
Use when listening at low volume levels.
On : The indicator lights: Boosts low and high frequencies to
give added punch to playback even at a low volume
level.
Off : The indicator goes off: Should normally be left in this
position.
NOTE:
This button does not operate when the DIRECT button is in
the on position.
8
TREBLE tone control
Use to adjust the high-frequency tone. The center position is
the flat (normal) position. When turned to the right, high-
frequency tones are emphasized; when turned to the left,
high-frequency tones are de-emphasized.
NOTE:
This control does not operate when the DIRECT button is in
the on position.
9
BASS tone control
Use to adjust the low-frequency tone. The center position is
the flat (normal) position. When turned to the right, low-
frequency tones are emphasized; when turned to the left,
low-frequency tones are de-emphasized.
NOTE:
This control does not operate when the DIRECT button is in
the on position.
z¿,?/ Direct Energy MOS
TREBLE
LOUDNESS
+ – +
VOLUME
CD
BALANCE
DIRECT
MIN MAX L
0
SPEAKERS B (ON/OFF) button/indicator
(A-209 only)
Use this button to listen to the speaker system connected to
SPEAKERS B terminals.
ON : The indicator lights. Sound is heard from the speaker
system.
OFF : The indicator goes off. No sound is heard from the
speaker system. Set to this position when listening
with headphones.
-
PHONES jack
When using headphones, insert the plug into this jack.
NOTE:
The speakers continue to output sound even when head-
phones are plugged into this jack.
To mute the sound from the speakers, press the SPEAKERS
button to OFF.
=
SPEAKERS A (ON/OFF) button/indicator
(A-209 only)
Use this button to listen to the speaker system connected to
SPEAKERS A terminals.
ON : The indicator lights. Sound is heard from the speaker
system.
OFF : The indicator goes off. No sound is heard from the
speaker system. Set to this position when listening
with headphones.
~
SPEAKERS button/indicator (A-109 only)
Use this button to listen to the speaker system connected to
the SPEAKERS terminals.
On : The indicator lights. Sound is heard from the speaker
system.
Off : The indicator goes off. No sound is heard from the
speaker system. Set to this position when listening with
headphones.
PANEL FACILITIES
TAPE 1/ TAPE 2
TUNER PHONO LINE
CD-R/MD MONITOR
INPUT SELECTOR
TAPE 2
MONITOR
R
The illustration shows the A-109.
7