Fracarro KSTT Instrucciones De Funcionamiento página 22

8.3 HEADEND SETUP AND KTP EMULATION MENU
Nav igation in the headend
programming menus
HEADEND
NAVIGATION
SETUP
OSD NAVIGATION
(Not av ailable)
Automatic
acknowledgement of the
HEADEND SCAN
headend connected to
the TPE
COPY
Restore the headend
FACTORY SETUP
def ault settings
SET ADDRESS
RESET MODULE
Emulation of the
KTP programmer
KTP
EMULATION
KSTT
Setting the output parameters
Measurements of the input and
output s ignal
Advanced Configuration
Confirm the settings by pressing the
KSTT
KSTT
Search Module....
Copy
KSTT
KSTT
KSTT
KSTT
KTP Emulation
KTP
EMULATION
8.4 KSTT GENERAL MENU
Setting the input parameters
INPUT
COFDM (OUTPUT)
MEASURE
ADVANCED
CONFIGURATION
pressing the S key after the modules programmation.
22
Ref er to the general
programming menu of the KSTT
transmodulator
Automatic search of the headend or
connected dev ice. Af ter searching,
the main menu can be seen using
the NAVIGATION f unction.
Paste
YES=V NO=X
KSTT
All
YES=V
modules
Select the new address
Change address
using the up/down
Current: xxx
arrows. Conf irm by
New: xxx
pressing the V key .
All
YES=V
modules
This f unction is not av ailable
f or the programming of the
V=OUTPUT
KSTT transmodulator
INPUT MENU
23
see page
COFDM (OUTPUT) MENU
24
see page
MEASURE MENU
25
see page
MENU ADVANCED CONFIG.
27
see page
key; save the settings by
Copy all parameters
except f or the output
channel, bandwidth,
singletone and adv anced
conf iguration
NO=X
NO=X