Overview Of Operating Controls - Sennheiser EM 3731 Instrucciones De Uso

Overview of operating controls

RF
A
300
100
30
10
μV
A Front panel
1
Rack mount "ears"
2
¼"
Headphone output,
3
Headphone volume control
4
Display (see next page)
5
Warning triangle indicating error states
6
esc button, backlit
7
Jog dial
8
save button, backlit
9
sync button, backlit
0
Headphone button, backlit
(except EM 3731 single receiver)
A
Infra-red interface
B
Display for external word clock synchronization
C
button, backlit
B Rear panel
D
3-pin mains socket
E
LED for LAN data transmission
F
RJ 45 socket for LAN connection
G
XLR-3 socket (male) for digital audio output,
digital balanced, AES3
BNC socket for word clock input (75 Ω)
H
*) The audio outputs marked with the number "1" output the audio signal of the left receiver of the twin
receiver (as viewed from the front); the audio outputs marked with the number "2" output the audio signal of
the right receiver.
% DEV 790.800
M
B
H
PEAK
z
100
03.03
BANK
AF COM
50
CH
10
(6.3 mm) jack socket
% DEV 790.800
RF M
A B
H
300 PEAK
z
100 100
03.03
BANK
AF COM
30
50
CH
10
μV 10
BNC socket for word clock daisy chain output (75 Ω)
I
J
XLR-3 socket (male) for Command output 2*,
balanced (EM 3732 Command twin receiver only)
K
XLR-3 socket (male) for audio output AF out 2*,
balanced (except EM 3731 single receiver)
L
XLR-3 socket (male) for Command output 1*,
balanced (EM 3732 Command twin receiver only)
M
XLR-3 socket (male) for audio output AF out 1*,
balanced
N
LED for booster supply of antenna input A
O
BNC socket, antenna input A
(ANT A – RF in, DC OUT, 50 Ω)
P
BNC socket, daisy chain output A
(ANT A – RF out)
Q
BNC socket, daisy chain output B
(ANT B – RF out)
R
BNC socket, antenna input B
(ANT B – RF in, DC OUT, 50 Ω)
S
LED for booster supply of antenna input B
T
Label with hazard warnings
U
Type plate
V
Label with frequency range for daisy chaining
Overview of operating controls
7