General Instructions - Ferroli ENERGY TOP B 80 Instrucciones De Uso

ENERGY TOP B
If the Remote Timer Control (optional) is connected to the boiler, the above ad-
A
justments are managed according to that given in table 1.
Table. 1
Heating temperature adjustment Adjustment can be made from the Remote Timer Control menu and the boiler
control panel.
DHW temperature adjustment Adjustment can be made from the Remote Timer Control menu and the boiler
(with optional hot water tank control panel.
installed)
Summer/Winter Switchover Summer mode has priority over a possible Remote Timer Control heating
demand.
Eco/Comfort selection (with On disabling DHW from the Remote Timer Control menu, the boiler selects the
optional hot water tank installed) Economy mode. In this condition, the button detail 7 - fig. 1 on the boiler panel
is disabled.
On enabling DHW from the Remote Timer Control menu, the boiler selects the
Comfort mode. In this condition it is possible select one of the two modes with
the button detail 7 -fig. 1.
Sliding Temperature Both the Remote Timer Control and the boiler card manage Sliding Tempera-
ture adjustment: of the two, the Sliding Temperature of the boiler card has prior-
ity.
System water pressure adjustment
The filling pressure with the system cold must be approx. 1.0 bar. If the system pressure
falls to values below minimum, the boiler card will activate fault F37 (fig. 14). Flashing of
the arrows (details 18 and 24 - fig. 1) together with the error code indicates which boiler
shell is in fault status.
fig. 14 - Low system pressure fault
Once the system pressure is restored, the boiler will activate the 120-second
A
air venting cycle indicated on the display by FH.
eco
reset
comfort
cod. 3541H060 - Rev. 02 - 04/2018
3. INSTALLATION

3.1 General Instructions

THE BOILER MUST ONLY BE INSTALLED BY QUALIFIED PERSONNEL, IN COMPLI-
ANCE WITH ALL THE INSTRUCTIONS GIVEN IN THIS TECHNICAL MANUAL, THE
PROVISIONS OF CURRENT LAW, THE NATIONAL AND LOCAL REGULATIONS,
AND THE RULES OF PROPER WORKMANSHIP.
ENERGY TOP B is a heat generator arranged to operate alone or in cascade (bank).
When two or more generators are installed in cascade with the original kits ENERGY
TOP B, respecting the prescriptionsFERROLIof this manual, they can be considered as
a single heat generator of total power equal to the sum of the powers of all the units con-
nected in cascade.
All the requirements of the current standards and regulations applicable to this "equiva-
lent" total heating capacity generator must be met. In particular, the place of installation,
safety devices and fume exhaust system must be adequate for the total heating capacity
of the bank of units.
In fact, each ENERGY TOP B is a complete and independent heat generator, equipped
with its own safety devices. In case of overtemperature, no water or no circulation in the
unit , the protection devices cause the unit to shutdown , preventing its operation.
The installation instructions given in the following paragraphs concern single units and
connection in cascade.
Given below are the possible configurations for connection in cascade.
Configurations in line
fig. 15 - Configuration - in line (example with 4 modules)
Table. 2 - Configurations in line
Heating power
max. Model Model
kW Module 1 Module 2
75 80 /
116 125 /
150 160
232 250
225 160 80
266 160 125
307 250 80
348 250 125
300 160 160
382 250 160
464 250 250
375 160 160
416 160 160
457 250 160
498 250 160
539 250 250
580 250 250
450 160 160
532 250 160
614 250 250
696 250 250
525 160 160
566 160 160
607 250 160
648 250 160
689 250 250
730 250 250
771 250 250
812 250 250
600 160 160
682 250 160
764 250 250
846 250 250
928 250 250
1003 250 250
1044 250 250
1078 250 250
1160 250 250
A
Combinations
Model Model Model
Module 3 Module 4 Module 5
/ / /
/ / /
/ / / 200
/ / / 200
/ / / 200
/ / / 200
/ / / 200
/ / / 200
/ / / 200
/ / / 200
/ / / 200
80 / / 200
125 / / 200
80 / / 200
125 / / 300
80 / / 300
125 / / 300
160 / / 300
160 / / 300
160 / / 300
250 / / 300
160 80 / 300
160 125 / 300
160 80 / 300
160 125 / 300
160 80 / 300
160 125 / 300
250 80 / 300
250 125 / 300
160 160 / 300
160 160 / 300
160 160 / 300
250 160 / 300
250 250 / 300
250 250 80 300
250 250 125 300
250 250 160 300
250 250 250 300
EN
Ø; A
/ 500
/ 500
1000
1000
1500
1500
1500
1500
2000
2000
2000
2500
2500
2500
2500
2500
2500
3000
3000
3000
3000
3500
3500
3500
3500
3500
3500
3500
3500
4000
4000
4000
4000
4000
4500
4500
5000
5000
73