5 Cavitron Jet Air Polishing Inserts; 6 Wireless Foot Control Operation; 7 Accessories And User Replaceable Parts; 7 1 Accessories - Cavitron JET Plus Instrucciones De Uso

8.5 Cavitron JET Air polishing Inserts

Air Polishing Insert Nozzle:
Tube-in-a-tube design delivers
precise air/water/powder
mixture at point
of delivery.
Insert Marking:
Manufacturer, Date (YDDD=Single digit
year and triple digit day of the year).

8.6 wireless Foot Control Operation

The foot control is a two-positioned momentary switch.
For scaling operation, the first position activates both the
ultrasonic energy and lavage at the insert tip. The second
position activates the Boost Mode. The Boost Mode (fully
depressed Foot Control) increases the ultrasonic power level
for quick, efficient removal of tenacious deposits without
adjusting the power level knob. To deactivate Boost Mode,
release foot control to first position.
For prophy operation, the first position activates Rinse
Mode. The second position activates Air Polishing Mode.
(Boost Indicator will not illuminate.)
• Pressing anywhere on the top of the foot control
activates the system.
NON-DEPRESSED
8.7 Accessories and user
replaceable parts
Accessories
8.7.1
1. AC Power Cord
2. Dual Position Foot Control (Wireless)
3. Auxiliary Foot Control Power Cable
4. Cavitron JET-Mate Sterilizable Handpiece
5. Prophy Handpiece Cleaning Wire
6. Cavitron 30K Ultrasonic Inserts
7. Cavitron DualSelect Dispensing system
8. Cavitron JET Air Polishing Insert
9. Cavitron JET Nozzle Cleaning Tool
Prophy Powder Delivery Tube: Directs air/pow-
der flow to insert tip.
DEPRESSED DEPRESSED
1st POSITION 2nd POSITION
O-Ring:
Seals water when Insert is fully seated in Handpiece.
O-ring should be replaced when worn.
User Replaceable Part Kits
8.7.2
1. Powder Bowl Cap O-Ring, Part Number 628052001
2. Powder Bowl Cap, Part Number 81728
3. Cavitron Insert Replacement O-ring Kits, 12/packs
Part Number 62351 (black) for plastic and soft grips
Part Number 62605 (green) for metal grips and prophy
4. Handpiece Cable O-Ring , Part Number 79357
5. JET-Mate Handpiece Nozzle Grip, 81717
6. Lavage (Water) Filter, 10/Pack, Part Number 90158
For detailed information, contact your local DENTSPLY
Professional Representative or authorized DENTSPLY
Professional Distributor.
SECTION 9: System Setup,
Operation and Techniques
for use

9.1 handpiece Setup

• Connect the Handpiece to the Cable Assembly by
aligning the electrical connections. If Cable Assembly
does not seat into the handpiece, gently rotate the
handpiece until contacts align, then fully insert handpiece.
• Hold empty handpiece in a semi-upright position over a
sink or drain. Activate the Foot Control until water exits
to bleed any air bubbles that might be trapped inside the
handpiece. Avoid letting water into the Powder Delivery
Port as clogging may result.
13
Insert Heater Rod: Heats
the delivered water for patient
comfort.