General Features; Technical Characteristics; Electrical System Set-Up; Preliminary Checks - Vimar ELVOX ESM2 Manual Del Instalador

Ocultar thumbs Ver también para ELVOX ESM2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
ACTO

GENERAL FEATURES

ACTO 600D automatic gate system for heavy-use residential and condominium sliding gates. The non-reversible, electromechanical actuator is equipped with
a low-voltage 24 Vdc motor and a mechanical release which enables the gate to be opened and closed manually. The motor operates a gear unit, lubricated
with permanent grease, which is enclosed in a thick but extremely compact die-cast aluminium housing. The electronic control board is integrated in the body
of the actuator, with the provision of a housing for the back-up battery (optional).

Technical characteristics

Supply voltage
Frequency
Board voltage supply
Motor voltage supply
Frequency of use
Rated motor power
Maximum motor speed
Rack
Operating temperature
Protection rating
Noise
Maximum gate weight
Dimensions (WxHxD)
Electrical system set-up (standard system)
5
Key
1-
Photocells
2-
Selector switch
3-
Flashing light
4-
Gear motor
5-
Rack

Preliminary checks

For the automatic gate system to function properly, the structure of the existing gate, or the one to be made, must meet the following
requirements:
- The wheels of the gate are mounted in such a position as to provide stability to the gate and are in a good condition and efficient.
- The rail is clear, straight and clean throughout its length with mandatory stops for both opening and closing.
- The top guide is aligned with the rail, the sliding blocks are intact and lubricated and with a clearance of approximately 1 mm. on each side
so as to facilitate the sliding of the gate leaf.
- The spaces between the moving and fixed parts of the gate are of the size required by the national standards or in any case comply with
safety standards by applying an adequate protection system.
- The weight of the gate must not exceed 600 kg
- No mechanical closing locks.
It is recommended to take the necessary steps to ensure the reliability and safety of the automatic gate system
1
4
230 V~
230 V~
120 V~
EN
ESM2 230 Vac (+10%, -10%)
ESM2.120 120 Vac (+10%, -10%)
50-60 Hz
22 Vac
24 Vdc
Heavy duty service
50 W
1300 RPM
Module 4
From -25°C to +55°C
IP45
< 70dBA
600 kg
308x270x225 mm
3
2
1
9

Publicidad

Tabla de contenido
loading

Tabla de contenido