Trusted Platform Module; Tpm Driver Installation; Activating Tpm - Clevo P270WM Manual Del Usuario

Trusted Platform Module

Before setting up the TPM functions you must initialize
the security platform.

Activating TPM

1. Restart the computer.
2. Enter the Aptio Setup Utility pressing F2 during the POST.
3. Use the arrow keys to select the Security menu.
4. Select TPM Configuration and press Enter.
5. Select TPM Support and press Enter. Select Enable and
press Enter.
6. Select TPM State, press Enter and select Enable to change
the TPM state to enabled. You will then need to press F4 to
save the changes and restart the computer.
7. As the computer restarts press F2 to enter the BIOS again and
go to the TPM Configuration menu.
8. Select Pending TPM operation, press Enter and select the
option you require (if you are initializing TPM you should select
Enable Take Ownership). You will then need to press F4 to
save the changes and restart the computer.
9. You can now install the TPM driver and then initialize the TPM.
32

TPM Driver Installation

1. Click Option Drivers (button).
2. Click 5.Install TPM Driver > Yes.
3. Click Install > Next.
4. Click the button to accept the license and click Next.
5. Click Next > Next > Install.
6. Click Finish > Yes to restart the computer.
If you have installed the driver without enabling and acti-
vating the TPM first, a confirmation message will appear
on restart.
Press F10 to enable and activate the TPM. However it is
recommended that you enter the BIOS and take ownership
of the TPM before configuration in Windows. Alternative-
ly press Esc to continue without making changes the
TPM.