Leakages; Assembly Faults - DeVilbiss AGMDPRO Serie Manual De Operación

Possible Problems in Operation (cont.)
Excessive overspray.
Dry spray.
Runs and sags.

Leakages

Fluid leaking from
Packing.
Fluid leaking or dripping
from front of gun.
Fluid leaking between the Spray Gun
and the Intermediate Plate.

Assembly Faults

Spray Gun does not locate onto
Intermediate Plate.
Spray Gun is loose when assembled
onto Intermediate Plate.
Spray Gun cannot be removed from
Intermediate Plate.
Air pressure too high.
Gun too far from work surface.
Air pressure too high.
Gun too far from work surface.
Gun motion too fast.
Fluid flow too low.
Too much material flow.
Material too thin.
Motion too slow.
Packing or Fluid Needle worn.
Fluid nozzle or fluid needle worn or
damaged.
Foreign matter in fluid nozzle.
Fluid needle dirty or stuck in needle
packing.
Wrong size fluid needle or fluid
nozzle.
O-Rings damaged or missing.
Locking Cam not locked or worn.
Locking Cam is not in the Unlock
position
Locking Cam has not been tightened.
Locking Cam has worn.
Locking Cam is not in the Unlock
position.
14
Reduce air pressure.
Adjust to correct target distance.
Reduce air pressure.
Adjust to correct distance.
Slow down.
Increase Fluid Flow or use larger
nozzle size.
Reduce Fluid Flow or change to
smaller fluid nozzle and fluid needle
size.
Mix correctly or apply light coats.
Increase Gun Traverse speed.
Replace.
Replace fluid nozzle and fluid
needle.
Clean.
Clean.
Replace fluid nozzle and fluid
needle.
Replace O-Rings using AGMDPRO-
29X-K5.
Lock Cam or replace using
AGMDPRO-406-K.
Turn Locking Cam to The Unlock
position using a 5mm key.
Turn Locking Cam fully to the lock
position using a 5mm key.
Replace using Cam service kit
AGMDPRO-406-K
Turn Locking Cam to The Unlock
position using a 5mm key.
© 2013 Finishing Brands UK Ltd.