Delta JT160 Manual De Instrucciones página 14

Machimbradora de banco de 6 pulg. con velocidad variable
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.
Using a square (C) Fig. 28, tilt the table to the 45 degree position and make sure the fence is 45 degrees to the
table. Adjust the fence if necessary.
7.
Using supplied hex wrench (No. 10, Fig. 4A), turn set screw (H) Fig. 29, until it contacts stop (G).
8.
These positive stops enable you to rapidly position the table to the 90 and 45 degree settings.
Make sure the fence is in level contact with the surface of the outfeed table.
ADJUSTING KNIVES
When it becomes necessary to replace or adjust the knives due to replacement or wear:
The knives are sharp.
Disconnect machine from power source.
1. Remove cutterhead guard.
2. To replace a knife, disengage the cutterhead lock (A) Fig. 30. Rotate cutterhead, loosen four screws (B) and remove
bar and knife. Insert new knife and replace bar and slightly tighten four screws (B).
BE EXTREMELY CAREFUL THAT YOUR HANDS DO NOT COME IN CONTACT WITH THE KNIVES.
3. To adjust the knives, make sure the cutterhead lock (A) Fig.30 is not engaged. Make sure screws (B) are not overly
tightened. Loosen each one half turn or only enough so knife can slide between locking plate and cutterhead.
4. Rotate cutterhead and engage cutterhead lock (B) Fig. 31, on cutterhead shaft as shown. This will position knives
for proper adjustment to the outfeed table.
5. Place a straight edge (D) Fig. 31, on the outfeed table extending out over the knife as shown. Using wrench (C)
supplied, turn screw (E) until knife just touches straight edge. Adjust knife at near end of cutterhead in the same
manner turning screw (F). Tighten four screws (B) Fig. 30, after adjustment is made.
NOTE: Make sure cutterhead lock (B) is disengaged after adjustment is completed and replace cutterhead guard.
C
Fig. 28
B
A
Fig. 30
B
14
H
G
Fig. 29
C
E
F
Fig. 31
D

Publicidad

Tabla de contenido
loading

Productos relacionados para Delta JT160

Tabla de contenido