Extension Cords; Functional Description - Delta JT160 Manual De Instrucciones

EXTENSION CORDS

Use proper extension cords. Make
sure your extension cord is in good condition and
is a 3-wire extension cord which has a 3-prong
grounding type plug and matching receptacle
which will accept the machine's plug. When using
an extension cord, be sure to use one heavy
enough to carry the current of the machine. An
undersized cord will cause a drop in line voltage,
resulting in loss of power and overheating. Fig. D-1
or D-2, shows the correct gauge to use depending
on the cord length. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier
the cord.
FOREWORD
The Delta JT160 is a 6" (152mm), Variable-Speed Bench Jointer with a designed cutting capacity of 6" (152mm) width
and 1/8" (3mm) depth. Unit includes a 10 amp, 120 volt motor with a variable speed range of 6,000 to 11,000 rpm,
and a cutting speed range of 12,000 to 22,000 cpm, a dust chute, a center-mounted fence, a two-knife cutterhead, a
cutterhead guard and lock, wrenches, and push blocks.
NOTICE: The photo on the manual cover illustrates the current production model. All other illustrations contained in the
manual are representative only and may not depict the actual labeling or accessories included. These are intended to
illustrate technique only.

FUNCTIONAL DESCRIPTION

MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Ampere
Rating Volts
0-6 120
0-6 120
0-6 120
0-6 120
6-10 120
6-10 120
6-10 120
6-10 120
10-12 120
10-12 120
10-12 120
10-12 120
12-16 120
12-16 120
12-16 120
7
Total Length Gauge of
of Cord in Feet Extension Cord
up to 25 18 AWG
25-50 16 AWG
50-100 16 AWG
100-150 14 AWG
up to 25 18 AWG
25-50 16 AWG
50-100 14 AWG
100-150 12 AWG
up to 25 16 AWG
25-50 16 AWG
50-100 14 AWG
100-150 12 AWG
up to 25 14 AWG
25-50 12 AWG
GREATER THAN 50 FEET NOT RECOMMENDED
Fig. D-1