General Safety Instructions - Oase Pond-Jet Instrucciones De Uso

General Safety Instructions

– Ensure that the electrical data on the type plate conforms to the mains
– Do not operate the unit when there are people in the water.
– Do not carry or pull the Fountain Unit by its connection lead cable.
– Swimming pools and garden ponds must meet the international and national
– Always disconnect the unit from the mains before performing any work on the unit.
– Ensure that the connection points (mains plugs) are always kept dry.
– Do not operate the Fountain Unit or the spotlights if the connection lead or
– Please send the Fountain Unit or Lighting Set directly to the supplier/manufacturer
Safety Instructions for 120 V/230 V
– Only connect the pump to a shock-proof socket installed according to the valid
– The use of installations, extension cables, connecting cables or adapters
– The pump must be supplied with a residual current of not more than
– Ensure that the connection lead/cable is protected and routed so that it cannot
Fountain Unit Assembly (Fig. 1)
1. Insert fountain holder (1) into the float opening (2).
2. Insert screw (4) with plain washer (5) into the bore hole.
3. Screw cap nut (6) and plain washer (5) onto the screw (4) from underneath.
4. Screw Atlantis 150 Pump (3) onto the fountain holder from underneath.
5. The Fountain Unit can now be taken to its installation site.
6. Put the Fountain Unit into the water.
Operation With 12 Jet Fountain (Fig. 2)
1. Remove the perforated disc (3) and the large O-ring (4).
2. Screw in plug (1) and small O-ring (2).
3. Keep the perforated disc (3) and the large O-ring (4) for 1" connection nozzles
Operation of the Unit with 1" Nozzle (not included in the
packaging, Fig. 3).
1. Position the perforated disc (3) and the large O-ring (4) on the fountain (5).
2. Screw the nozzle (7) with the small O-ring (2) in the centre.
3. Keep the plug (1) for operating the 12 jet fountain in a safe place.
Operating the Unit with the Lunaqua 10 triple light set.
Attention!
1. Observe the Directions for Use for the spotlights.
2. Ensure that the spotlights are completely below the surface of the water.
238-03 Pond-Jet.p65
GB Operating instructions Gebrauchsanweisung
specifications.
installation regulations. Please ask your electrician.
housing appear to be defective.
for repair or cable replacement.
national regulations (VDE, EN...) and which is connected to an earth conductor.
Please ask your electrician.
without an earthing contact in not permitted.
30mA via an error control device (RCD).
present an obstruction.
Attention: Screw and cap nut should only be hand tightened.
in a safe place. (See Accessories for nozzle).
7
GB
13.03.2003, 08:50
7