Mounting And Connecting - Phocos CML-V2 Manual De Instrucciones

Mounting and Connecting

The controller is intended for indoor use only. Protect it from
direct sunlight and place it in a dry environment. Never install it
in humid rooms (like bathrooms). The controller measures the
ambient temperature to determine the charging voltage. Controller
and battery must be installed in the same room.
The controller warms up during operation, and should therefore
be installed on a non flammable surface only.
REMARK: Connect the controller by following the steps described
below to avoid installation faults.
1
Mount the controller to the wall with
screws that fit to the wall material.
Use screws with 4 mm shaft and max.
8 mm head diameter, no counter sink.
Mind that the screws have to carry also
the force applied by the wiring.
Make sure that the ventilator slits on
the sides are unobstructed.
21