Recycle; Operation; Charge Procedure - GreenWorks Pro CAC801 Manual Del Operador

Symbol Explanation
For indoor use only
Before charging, read the instructions
Fuse
5

RECYCLE

Separate collection. You must not discard
with usual household waste. If it is necessa-
ry to replace the machine, or if it is no more
use to you, do not discard it with household
waste. Make this machine available for sepa-
rate collection.
Separate collection of used machine and
packaging let you recycle materials and use
them again. Use of the recycled materials
helps prevent environmental pollution and
decreases the requirements for raw materi-
als.
At the end of their useful life, discard batter-
ies with a precaution for our environment.
The battery contains material that is danger-
ous to you and the environment. You must
remove and discard these materials separate-
ly at a equipment that accepts lithium-ion
batteries.
6

OPERATION

6.1

CHARGE PROCEDURE

Before use charge the battery pack fully to make sure that
the battery pack can get the maximum run time. This battery
pack does not have a memory. You can charge it all the
time.
1. Connect the plug of charger (2) to an AC power outlet.
2. Put the battery pack (1) into the charger (2).
NOTE
English
This is a diagnostic charger. The Charger LED Light (3)
illuminates in a specified order to show the current battery
status. They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING
FULLY CHARGED
BATTERY IS TOO WARM (REMOVE
FOR APPROX. 30 MINUTES TO AL-
LOW TO COOL)
DEFECTIVE BATTERY (REMOVE
AND REPLACE WITH A NEW BAT-
TERY)
1. Put the battery pack into the charger.
• If the status LED blinks RED, remove the battery
pack from the charger for 1 minute.
2. Put the battery pack into the charger again.
• If the status LED blinks GREEN, the battery pack is
good.
• If the status LED stays blinking RED, remove the
battery pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
• If the status LED shows blinks GREEN, the battery
pack is good.
• If the status LED stays blinking RED, the battery
pack is defective and it is necessary to replace the
battery pack.
Low voltage charging
• It can take 20 hours to fully charge the battery if the
battery stored with no little no charger for a long period
of time.
• If the battery is not used for a long time, the charger will
go into the recovery mode, which needs to get 20 hours to
fully charge the battery.
• It can extend the life of the battery. When it is fully
charged, the next charge will get back to standard
charging.
5
EN
GREEN
BLINKING
GREEN
RED
RED
BLINKING