Examine The Charger; Maintenance; Clean The Machine; Stow The Machine - GreenWorks Pro CAC801 Manual Del Operador

EN
6.2

EXAMINE THE CHARGER

If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move
the charger and battery pack to a location where the
temperature is between 6 ˚C and 40˚C .
If you put the battery pack into the charger in warm or hot
environment, the charger LED light is red. Pull out the
battery pack and let the battery cool for approximately 30
minutes.
7

MAINTENANCE

7.1

CLEAN THE MACHINE

Keep the air vent free of blockage, saw dust, and wood dust.
Do not spray, wash, or put the air flow in water.
• Clear the unwanted material out of the air vent with a
vacuum.
• Clean housing and the plastic components with a dry and
soft cloth.
Do not use strong solvents or detergents on the plastic
housing or components.
7.2

STOW THE MACHINE

• Remove the battery pack before you store the charger or
disconnect the charger.
8

TROUBLESHOOTING

PROBLEM
Charger doesn't
work. Charger
shows defective
mode. (LED
flashes Red)
WARNING
NOTE
IMPORTANT
POSSIBLE SOLUTION
CAUSE
Try to remove and
reinsert the battery
pack in the charg-
er.
Battery pack or
Try charging a dif-
charger is defective
ferent battery
or there is a bad
pack.
connection be-
tween the battery
Unplug the charg-
pack and charger.
er and wait until
the red LED goes
out, then reconnect
the plug to the
power supply.
English
PROBLEM
Charger doesn't
work. Charger
shows evaluation
mode (LED indi-
cates Red solid
ON).
9

TECHNICAL DATA

Model
Voltage
Input
Output
10

LIMITED WARRANTY

Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of four (4)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been hired or rented for industrial/commercial use, and that
have been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to misuse,
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
2. The unit, if it has not been operated and/or maintained in
accordance with the owner's manual; or
3. Normal wear, except as noted below;
4. Routine maintenance items such as lubricants, blade
sharpening;
5. Normal deterioration of the exterior finish due to use or
exposure.
6
POSSIBLE SOLUTION
CAUSE
Allow the battery
pack to reach nor-
mal temperature.
Battery pack is ei-
Charging will be-
ther too hot, or too
gin when the bat-
cold.
tery pack returns
to 3°C-47°C
(37°F-117°F).
CAC801
60 V
120V AC 50/60Hz, 2.5A Max
60V DC 3A