Bosch GSH 4 Instrucciones De Servicio página 7

EURO • Printed in Germany • BA 1 619 929 576 • GSH 4 • GB • OSW 02.03
GSH 4 (576) - Buch Seite 1 Montag, 4. März 2002 12:54 12
Tool Specifications
Demolition Hammer
Order number
Rated power [W]
Impact rate [bpm] 2 440
Impact energy
per stroke [J]
Chisel positions
Chiselling perform-
ance in concrete of [cm
medium hardness min]
Tool holder
Lubrication
Weight (without
accessories) approx. [kg]
Protection class
Please observe the order number of your machine.
The trade names of the individual machines may vary.
Noise/Vibration Information
Measured values determined according to
2000/14/EC (1.60 m height, 1 m distance away)
and EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 88 dB (A); sound
power level: 101 dB (A).
Wear hearing protection!
The typical weighted acceleration is 14 m/s
Intended Use
The machine is intended for chiselling work in
concrete, brick, stone and asphalt as well as for
driving and compacting with appropriate acces-
sories.
Machine Elements
1 Dust protection cap
2 Locking sleeve
3 Chisel adjusting ring (Vario-lock)
4 On/Off switch
5 Auxiliary handle
Not all of the accessories illustrated or described are
included as standard delivery.
7 • 1 619 929 576 • TMS • 28.02.02
GSH 4
0 611 312 1..
850
7
general safety notes in the enclosed booklet
12
must be observed. Before using for the first
time, ask for a practical demonstration.
3
/
450
SDS-max
Permanent
central lubrication
4.8
/ II
2
.
English - 1
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
Wear hearing protection.
Wear safety glasses and sturdy shoes.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assist-
ance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage or may cause an electric
shock.
Hold the power tool only by the insulated
gripping surfaces, when performing an op-
eration where the cutting tool may run into
hidden wiring or its own cord.
Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the op-
erator.
Always direct the cable to the rear away from
the machine.
Insert the mains plug only when the machine is
switched off.
Use the machine only with the auxiliary han-
dle 5.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Always switch the machine off and wait until it
has come to a standstill before placing it down.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.