Operation - Vacuum Packing In Bags; Operation - Vacuum Packing With Film From The Roll - Unold 48016 Instrucciones De Uso

OPERATION - VACUUM PACKING IN BAGS

1. Prepare the appliance as descri-
bed in the section "Preparing the
appliance for operation" .
2. Open the cover of the appliance.
Check to make sure the seal is
inserted properly. If there are any
foreign objects such as crumbs on
the seal, they have to be removed,
since otherwise no vacuum can be
created.
3. Fill the bag with the food to be
vacuumed. For optimal results,
the bag should not be too full.
Leave about 8 cm between the
contents and the edge of the bag.
4. Place the open end of the bag in
the middle of the vacuum packing
chamber.
5. Close the cover and press the two
catches on the right and left of
the appliance inward at the same
time.
6. Press the button "Vacuum &
Seal". The indicator lamp lights
up red to indicate that vacuum
packing is in progress.

OPERATION - VACUUM PACKING WITH FILM FROM THE ROLL

1. Prepare the appliance as descri-
bed in the section "Preparing the
appliance for operation".
2. Open the cover of the appliance.
Check to make sure the seal is
inserted properly. If there are any
foreign objects such as crumbs on
the seal, they have to be removed,
since otherwise no vacuum can be
created.
3. Cut the required amount of film
from the roll. Caution: Add at
least 7.5 cm for vacuum packing.
If you wish to reuse the bag, you
have to add even more: allow
2.5 cm for each vacuum packing
process.
4. Place one open end of the film
over the sealing gasket. You do
not have to insert this end of
the bag into the vacuum packing
24
7. When the optimal vacuum result
has been achieved, the bag is
sealed: the indicator lamp shows
this by lighting orange.
8. The appliance starts with sealing,
the vacuum pump no longer
works.
9. When the process is completed,
the indicator lamp lights green
and the two catches on the appli-
ance open automatically.
10. Now open the lid and remove the
bag.
11. The vacuum packing process is
completed and the food in the
bag is vacuum sealed.
12. If you only wish to seal the bag
without a vacuum, just press the
button "Seal Now".
13. If you wish to interrupt the vacuum
packing process, press the button
"Vacuum & Seal" again.
14. Always check whether the vacuum
result meets your requirements
and ensure that the sealing strip
is complete and flawless.
chamber, since the bag first has
only to be sealed, without crea-
ting a vacuum.
5. Close the cover and press the two
catches on the right and left of
the appliance inward at the same
time.
6. Press the button „Seal Now". The
indicator lamp lights up orange
to indicate that the appliance is
sealing. The vacuum pump is still
off.
7. After a short time the indicator
lamp lights up red, the appli-
ance works for another approx.
2 seconds.
8. Once the process is completed,
the cover of the appliance opens
slightly and the indicator lamp
lights green.
9. Open the lid and remove the bag.