Peg-Perego Aria OH Instrucciones De Uso página 11

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ CAREFULLY READ INSTRUCTIONS AND KEEP FOR FUTURE USE.
THE CHILD'S SAFETY COULD BE PUT AT RISK IF THE INSTRUCTIONS ARE NOT
FOLLOWED.
_ THIS PRODUCT IS DESIGNED FOR A CHILD WHOSE MAXIMUM WEIGHT IS 45
POUNDS (20 KG) AND WHOSE MAXIMUM HEIGHT IS 43 INCHES (110 CM). THIS
SHOPPER BASKET IS DESIGNED TO CARRY A MAXIMUM WEIGHT OF 11 POUNDS (5
KG). ANY CUPHOLDER EVENTUALLY PROVIDED WITH THIS UNIT IS DESIGNED TO
CARRY A MAXIMUM WEIGHT SPECIFIED ON THE CUPHOLDER ITSELF. ANY POACH
OR POCKET PROVIDED WITH THIS UNIT IS DESIGNED TO CARRY A MAXIMUM
WEIGHT OF 0.44 POUNDS (0.2 KG).
_ FAILURE TO FOLLOW MANUFACTURER'S SPECIFICATIONS OR USE OF ACCESSORIES
OTHER THAN THOSE APPROVED BY THE MANUFACTURER MAY CAUSE THE UNIT
TO BECOME UNSTABLE.
_ AVOID SERIOUS INJURY FROM FALLING OR SLIDING OUT. ALWAYS USE COMPLETE
5 POINT SEAT BELT.
_ NEVER LEAVE YOUR CHILD UNATTENDED.
_ ALWAYS USE ALL THE BRAKES WHENEVER PARKED.
_ TO AVOID SERIOUS INJURY, WHEN MAKING ADJUSTMENTS ENSURE THE CHILD'S
BODY IS CLEAR OF ALL MOVING PARTS.
_ ALL OPERATING AND ASSEMBLY PROCEDURES SHOULD BE PERFORMED BY AN
ADULT.
_ DO NOT LIFT THE STROLLER BY GRIPPING THE FRONT BAR. THE FRONT BAR IS NOT
DESIGNED TO WITHSTAND LOADS.
_ ENSURE THAT THE STROLLER IS OPENED CORRECTLY AND LOCKED IN POSITION
OF USE.
_ CHECK TO MAKE SURE THAT THE CAR SEAT OR THE BABY CARRIAGE IS CORRECTLY
FASTENED TO THE STROLLER (WHERE APPLICABLE).
_ DO NOT DRIVE THIS PRODUCT AROUND STAIRS OR STEPS; CARE MUST BE TAKEN
IF UNIT IS USED ON STAIRS OR ESCALATORS.
_ DO NOT USE THE PRODUCT IF IT HAS BROKEN OR MISSING PARTS.
_ DO NOT USE NEAR FIRE OR EXPOSED FLAME.
_ NOTICE: THIS ARTICLE MEETS OR EXCEEDS ALL REQUIREMENTS COVERED IN ASTM
F833 STANDARD AND LATEST REVISIONS.
INSTRUCTIONS
1 OPENING THE STROLLER: (fig_a) To open the stroller, completely disconnect the two fasteners, press the
button (1) on the handlebar and simultaneously press the handle (2), firmly lift the handlebar upwards (fig_b),
then push it downwards until it clicks into place (fig_c).
2 FITTING THE REAR WHEELS: Take care to mount the two wheels fitted with brakes on the rear of the stroller.
Fit the wheel, push button while pushing the wheel further until you hear the final click: the wheel is securely
fastened.
3 FITTING THE FRONT WHEELS: To mount the front wheels, lower the lever (fig_a) and click the wheels into place
(fig_b).
4 FITTING THE FRONT BAR: Attach the front bar as shown in the figure.
5 HOOD: To attach the hood, insert the tabs into the notches (fig_a) and button the hood to the rear of the
backrest (fig_b).