Peg-Perego Aria OH Instrucciones De Uso página 12

6 The hood can be moved to different positions while your child is sleeping (fig_a). To remove the hood, press
the side buttons while lifting the hood off (fig_b).
7 CUP HOLDER: The cup holder can be placed on the left or right hand side of the stroller, thanks to the
attachment which is already fitted on both sides. To fit the cup holder, click it on (fig_a). Fitted cup holder
(fig_b).
8 BRAKE: Press down on the brake lever situated on the rear wheel unit to set the brake on the stroller. Lift the
lever to release the brake. Always set the brake when the stroller is at a standstill.
9 5-POINT SAFETY HARNESS: to attach the safety harness, insert the two buckles of the waist strap (with
shoulder straps attached) into the leg divider strap until it clicks into place (fig_a). To release, press both sides
of the buckle and pull the waist strap to the sides at the same time (fig_b).
10 To secure the child with the safety harness, insert the shoulder strap buckle in the special holder on the
backrest (fig_a) and, after fastening the harness, detach the buckle from the backrest to allow the child
more freedom of movement (fig_b). Position the shoulder strap buckle just below the child's shoulders to
ensure the straps remain in place without slipping (fig_c). To tighten the waist strap, pull on both sides in
the direction of the arrow (fig_d). To loosen it do the opposite. The waist strap can be tightened as far as the
safety lock (fig_e).
11 ADJUSTING THE BACKREST: To recline the backrest, lower the backrest adjuster button while pushing the
backrest down (fig_a). To raise the backrest, push the backrest adjuster button upwards (fig_b).
12 SWIVELLING WHEELS: Lower the lever (fig_a) to allow the front wheels to swivel. Lift the lever for fixed wheels
(fig_b).
13 FRONT BAR-CHILD TRAY The front bar-child tray can be opened to make it easier for the child to get in and out
of the stroller when he or she is older. To open the front bar on one side only press one of the two buttons (1
or 2) and lift it upwards. To remove the front bar-child tray, press the two buttons as shown in the figure while
pulling it upwards (fig_a). To remove it press both buttons (1 and 2) while pulling it upwards (fig_b). Do not
place boiling-hot drinks on the front bar-child tray; this could be dangerous.
14 REPLACING THE BASKET: If it is necessary to replace the basket, fasten the front of the new basket to the hooks
(fig_a) and close the buttons on the back (fig_b).
15 REMOVING THE WHEELS: The wheels on the stroller are removable. To remove the front wheels, set them to
swivel, press the levers (fig_a) and at the same time push the wheel until it comes off (fig_b).
16 To remove the rear wheels, press the button (fig_a) and at the same time push the wheels down until they
come off (fig_b).
17 FOLDING UP THE STROLLER: If the hood is attached, close it before folding up the stroller. To close the stroller,
move the handle in the same way as you do when opening it: press the button (1) on the handlebar and at the
same time push the handle (2).
18 Push the backrest and the hood towards the stroller, while lowering the handlebar into its housing (fig_a).
Check to make sure that the stroller is fastened securely with the safety clip (fig_b). The folded-up stroller will
stand upright by itself and it is possible to carry it thanks to the practical handle (fig_c).
19 REMOVABLE LINING: To remove the lining from the stroller, first of all remove the hood, then remove the little
cover on the side by pressing on it (fig_a). Push the pin upwards and then outwards (fig_b). Slip the pin out of
the hole in the sack. Repeat on the other side.
20 To detach the sack from the seat, remove the leg divider from under the seat (fig_a), and unbutton (fig_b).
Unscrew the safety belt from both sides (fig_c) and slip the sack off the stroller (fig_d).
GANCIOMATIC SYSTEM
Ganciomatic is the practical, fast system for attaching the Primo Viaggio car seat to the stroller. The car seat is
fitted with the Ganciomatic System, and is sold separately.
21 STROLLER GANCIOMATIC FASTENERS: To raise the Ganciomatic fasteners on the stroller, pull the sack up
in the seat corners and lift the two fasteners. They will automatically move outwards (fig_a). To lower the
Ganciomatic fasteners, push them inwards and then down (fig_b).
22 STROLLER + CAR SEAT: To fasten the car seat to the stroller: set the brake on the stroller, remove the hood,
completely lower the backrest and raise the Ganciomatic fasteners. Place the car seat, facing the adult, on the
stroller and push down until it clicks into place. Do not remove the front bar from the stroller when attaching
the car seat. See the car seat's user manual for instructions on how to detach it from the stroller.
ACCESSORY LINE
23 RAIN CANOPY: The rain canopy made of transparent with elastic around the edge can be fastened over
the hood on the Aria stroller. This rain canopy has been designed for use with the "Primo Viaggio" car seat
attached to the stroller as well, to guarantee total protection.
24 BORSA CAMBIO: Diaper-Changing Bag with pad for changing the baby. Attaches to the stroller.