Speaker Impedance Settings - Onkyo A-9110 Manual De Instrucciones

Speaker impedance settings

1
2
3
14
4Ω
8Ω
SETUP
Depending on the speakers you connect, you may need to
change the speaker impedance setting on this unit. Refer to
the page describing speaker connection (p9) and do the
following procedures if the change is required.
1. Press SETUP on the remote controller.
2. Press D/C on the remote controller several times so
that input source indicators on the unit, such as "LINE 1"
and "LINE 2", start blinking.
(BLINKING)
0 The indicators blink and the current setting is
displayed.
3. Press B/A on the remote controller to change the
setting.
- 4 ≠: "LINE 1" and "LINE 2" indicators are blinking
- 8 ≠ (default value): "LINE 1", "LINE 2", "LINE 3" and
"LINE 4" indicators are blinking
4. To exit the settings, press SETUP.
0 The setting mode ends after 5 seconds elapse with no
operations performed.
Preparations
/ / /