Specifications - Onkyo A-9110 Manual De Instrucciones

Specifications

Amplifier (Audio) section
Rated Output Power (FTC) (North American)
With 8 ohm loads, both channels driven, from 20-20 kHz;
rated 30 watts per channel minimum RMS power, with no
more than 0.7% total harmonic distortion from 250
milliwatts to rated output.
With 8 ohm loads, both channels driven, from 1 kHz;
rated 42 watts per channel minimum RMS power, with no
more than 0.9% total harmonic distortion from 250
milliwatts to rated output.
With 4 ohm loads, both channels driven, from 20- 20 kHz;
rated 50 watts per channel minimum RMS power, with no
more than 0.9% total harmonic distortion from 250
milliwatts to rated output.
With 4 ohm loads, both channels driven, from 1 kHz;
rated 57 watts per channel minimum RMS power, with no
more than 0.9% total harmonic distortion from 250
milliwatts to rated output.
Rated Output Power (IEC) (European)
2 ch k 50 W at 4 ohms, 20 Hz-20 kHz, 2 ch driven of
0.9% THD
2 ch k 60 W at 4 ohms, 1 kHz, 2 ch driven of 0.9% THD
2 ch k 30 W at 8 ohms, 20 Hz-20 kHz, 2 ch driven of
0.7% THD
2 ch k 43 W at 8 ohms, 1 kHz, 2 ch driven of 0.9% THD
Dynamic Power (*)
(*)IEC60268-Short-term maximum output power
220 W (3 ≠, Front)
190 W (4 ≠, Front)
110 W (8 ≠, Front)
Input Sensitivity and Impedance
200 mV/47 k≠ (LINE (RCA))
4 mV/47 k≠ (PHONO MM)
Rated RCA Output Voltage and Impedance
0.2 V/2.3 k≠ (LINE OUT)
1 V/500 ≠ (SUBWOOFER PRE OUT)
Deviations from RIAA Equalizer
n0.5 dB (MM 20 Hz-20 kHz)
Phono Maximum Input Signal Voltage
70 mV (MM 1 kHz, 0.5%)
Frequency Response
10 Hz - 100 kHz/i1 dB, j3 dB (DIRECT)
Tone Control Characteristics
n10 dB, 100 Hz (BASS)
n10 dB, 10 kHz (TREBLE)
Signal to Noise Ratio
103 dB (IHF-A, LINE IN, SP OUT)
78 dB (IHF-A, PHONO IN, SP OUT)
Speaker Impedance
4 ≠ - 16 ≠
Supported impedance of Headphones
8 ≠ - 600 ≠
Headphones Frequency Response
30 Hz -100 kHz
22
General
Power Supply
AC 120 V, 60 Hz (North American)
AC 220-230 V, 50/60 Hz (European)
Power Consumption
130 W
0.1 W (Stand-by, North American)
0.2 W (Stand-by, European)
Dimensions (W k H k D)
435 mm k 129 mm k 330 mm
17-1/8" k 5-1/16" k 13"
Weight
7.0 kg (15.4 lbs)
Audio Inputs
Analog
PHONO, LINE1, LINE2, LINE3, LINE4
Audio Outputs
Analog
LINE OUT L/R
SUBWOOFER PRE OUT
Speaker Outputs
SPEAKERS: L/R
(North American models support banana plugs.)
Phones
PHONES (Ø6.3 mm)
Others
RI: 1
Others