Fagor BMF-200X Manual Del Usuario página 8

8
6. Loosen screws used to hold the middle
hinge and remove middle hinge. Then
remove the lower door.
7. Place the lower door on a smooth
surface facing upwards. Change the
handle to the right side by following step
5 described in page 7. Remove the self-
tapping screws, detach the stop block
and door holder.
① Handle covers
② Special self-t apping screws
③ Handle
④ Screw hole covers
Turn the door holder 180° and then install
it and the stop block on the opposite
side with the self-tapping screws.
1
8. Change the screw hole covers on the
middle cover plate from left to right.
⑤ Door holder
⑥ Stop block
⑦ Self-t apping screws
2
9. Place the refrigerator fl at on the fl oor,
remove adjustable feet and self-tapping
screws. Remove the front foot fi xed
board and lower hinge part.
① Lower hinge part（right）
② Front foot fixed board
③ Adjustable bottom feet part
④ Self-t apping screws
10. Unscrew the lower hinge, change it
to the opposite side and reattach and
mount washer.
11. Change lower hinge part to the left
side and front foot fi xed board to the
right side, then fasten with self-tapping
screws. Finally install adjustable feet.
Lower hinge part (left)
12. Remove the lower door by pulling down
and align the lower hole site and upper
hinge axis. Turn the middle hinge piece
180°, change the washer on the axis to
the upper side, adjust the middle hinge
to the appropriate position and then
reinstall it.
Note: The washer may
stick to lower door.
Washer
Note: The washer may
stick to lower door.
Washer