Maintenance Instructions; Moving And Storage Instructions; Before Returning For Repairs - Schumacher Electric SP-1500 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The Schumacher SP-1500 is a battery charger/maintainer that charges small batteries
and maintains large 12 volt batteries, keeping them at full charge. However, if you were
to use this unit to charge a large battery, you may lose some of the battery's capacity.
This would cause the battery to be unable to hold a charge and become useless.
NOTE: The maintain mode technology utilized in Schumacher maintainers allows you
to safely maintain a healthy battery for extended periods of time. However, problems
with the battery, electrical problems in the vehicle, improper connections or other
unanticipated conditions could cause excessive current draws. As such, occasionally
monitoring your battery and the maintaining process is recommended.
Using The Quick-Disconnect Cable Assemblies
Connect either of the two output cable assemblies to the solar panel. Do not place the
solar controller on wet ground, anywhere it could be accidently stepped on or in a place
or position where it could fall while being used. Never use the output cables together or
for other applications, as reverse polarity and/or overcharge conditions will occur.
50 Amp Battery Clip Cable Assembly
1. Connect the end of the solar charge controller output cable to the end of the 50 amp
battery clips cable.
2. Follow the steps in sections 6 and 7 to connect the output clips to the battery.
3. After a good electrical connection is made to the battery, connect the solar panel
to the charger controller and place it in the sun, per the instructions in step 4 of the
solar panel location section.
12V Accessory Plug Cable Assembly
Maintain or charge your battery without lifting the hood.
1. Connect the end of the 12V accessory plug cable to the solar charge controller.
2. Insert the 12V accessory plug into the 12V accessory outlet.
3. Route the power cord from the solar panel through the vehicle's open window.
4. Place the solar panel in the sun, per the instructions in step 3 of the Operating
Instructions section.
12.

MAINTENANCE INSTRUCTIONS

12.1
After use and before performing maintenance, unplug and disconnect the solar panel
(see sections 6, 7 and 8).
12.2
Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips,
cords and the solar panel.
12.3
The solar panel uses a glass substrate; please handle with care.
12.4
Always keep the glass surface clean using a soft cloth in order to ensure its maximum output.
12.5
Ensure that all of the solar panel components are in place and in good working
condition, for example, the plastic boots on the battery clips.
12.6
Servicing does not require opening the unit, as there are no user-serviceable parts.
12.7
All other servicing should be performed by qualified service personnel.
13.

MOVING AND STORAGE INSTRUCTIONS

13.1
Store the solar panel unplugged, in an upright position.
13.2
Store inside, in a cool, dry place.
13.3
Do not store the clips clipped together, on or around metal, or clipped to cables.
13.4
If the solar panel is moved around the shop or transported to another location, take care
to avoid/prevent damage to the cords, clips and solar panel. Failure to do so could result
in personal injury or property damage.
14.

BEFORE RETURNING FOR REPAIRS

14.1
When a maintaining or charging problem arises, make certain that the battery is capable
of accepting a normal charge. Double check all connections, the solar panel clips for
7

Publicidad

Tabla de contenido
loading

Tabla de contenido