Assembly Instructions - Schumacher Electric SE-1520 Manual Del Usuario

9. ASSEMBLY INSTRUCTIONS

9.1 It is important to fully assemble your
charger before use. Remove all cord wraps
and uncoil the cables prior to using the
(2) 10-32 thread cutting screws
(2) 10-24 x 5/8" thread cutting screws
(4) 8-32 x 1" pan head screws
(2) wheels
(1) axle
(2) axle caps
(2) axle brackets
(1) handle
(1) foot
9.2 Attach the foot: Remove the charger
from the packing materials and place
upside down on
a flat surface.
Attach the foot
and secure it
with the two 10-
24 x 5/8" thread
cutting screws
provided.
9.3 Assemble the wheels and axle: Hold the
axle upright on the floor or work surface.
Then, using a hammer, tap one of the axle
caps onto the top end of the axle. Be sure
to tap the axle cap on straight. Slide both
wheels onto the axle with the recessed
hubs facing out as shown. Install the
second axle cap.
PARTS
1
1
4
4
battery charger. Follow these instructions
for assembly.
TOOLS NEEDED
3/8" wrench (for mounting foot)
1
5/16" wrench (for mounting wheels)
1/4" wrench (for mounting handle)
hammer
flat-head screwdriver
Phillips-head screwdriver
9.4 Mount the axle to the charger: Place
one end of each bracket into the slot on
the bottom of the charger. Place the axle
assembly under each bracket. Attach
the brackets, using the two 10-32 thread
cutting screws provided.
NOTE: Be careful not to drop the brackets
inside of the charger case.
4
9.5 Attach the handle: Turn the charger
right side up onto its foot and wheels.
Align the handle, so the screw holes
are aligned with the
screw holes on each
side of the charger.
Attach the handle,
using the four 8-32 x 1"
pan head screws
provided.
• 6 •
2
2
5
5
2
5