Operation - Ryobi YN301PL Manual Del Operador

WARNiNG:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
dANGER:
Do not disassemble check valve, tank drain valves or
safety relief valve with air in tank — bleed tank. Failure
to depressurize tank could result in explosion and/or
serious personal injury.
WARNiNG:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict severe injury.
WARNiNG:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result
in objects being thrown in your eyes and other possible
serious injuries.
WARNiNG:
This equipment incorporates parts, such as snap
switches, receptacles, and the like that tend to produce
arcs or sparks and, therefore, when located in a garage,
it should be in a room or enclosure provided for the
purpose, or should be 18 in. (457 mm) or more above
the floor.
WARNiNG:
Do not attach any tools to the open end of the hose
until start-up has been completed. Attaching a tool
prematurely could result in accidental operation causing
serious injury.
ASSEMBLY
WARNiNG:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.

OPERATiON

CAUTiON
Do not use in an environment that is dusty or otherwise
contaminated. Using the air compressor in this type of
environment may cause damage to the unit.
APPLiCATiONS
Air compressors are utilized in a variety of air system
applications. Match hoses, connectors, air tools, and
accessories to the capabilities of the air compressor.
You may use this product for the purposes listed below:
 Operating some air-powered tools
 Operating air accessories such as air nozzles and
inflators
 Operates some air powered paint spraying products
TRANSPORTiNG THE AiR COMPRESSOR
See Figure 3 - 4, page 17.
The air compressor should be moved as shown in figure 4.
This will help you to avoid damaging the wheels or the air
compressor by rolling it over items in its path.
To move the air compressor:
 Ensure AUTO/OFF switch is in the OFF position and the
air compressor is unplugged.
NOTE: To reduce the risk of tripping secure the 25 ft. hose to
the clip located outside the integrated coil hose retainer and
make sure the power cord is secured in the cord wrap.
 Pull the folding handle out
 Facing the back of the air compressor, grasp the folding
handle firmly with one hand.
 Lift the air compressor toward you until it balances on
the wheels.
 Turn around and pull the unit along behind you to the
desired location.
 Lower the air compressor until it sits securely on a flat
surface.
11 - English