Operation - Ryobi P731 Manual Del Operador

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
Do not leave items to be inflated unattended while infla-
tor is in use. These items can burst and could cause
serious injury.
NOTICE:
The inflator is not designed for continuous use. For every
ten minutes of inflator use, ten minutes of cool down time
are required.
WARNING:
Since the pressure gauge is not calibrated, and is
therefore not binding for exact values, tire pressure
must be checked using a reliable measuring device be-
fore driving a vehicle with vehicle tires inflated with the
inflator. Driving a vehicle with improperly inflated tires
could result in serious injury.
NOTICE:
The inflator is capable of inflating to 150 PSI. To avoid
over inflation, carefully follow instructions on items to be
inflated. To avoid product damage, never exceed recom-
mended pressures.

OPERATION

APPLICATIONS
You may use this inflator for the purpose listed below:
 Inflating high pressure items like motorcycle, car, and
bicycle tires
 Inflating and deflating low pressure items like air mat-
tresses, rafts and floats
NOTE: The inflator is not designed for commercial application.
This product will accept Ryobi One+ 18 V lithium-ion battery
packs and Ryobi One+ 18 V nickel-cadmium battery packs.
For complete charging instructions, refer to the Operator's
Manuals for your Ryobi One+ battery pack and charger
models.
BATTERY PROTECTION FEATURES
Ryobi lithium-ion batteries are designed with features that
protect the lithium-ion cells and maximize battery life.
If the product stops during use, the battery needs to be
recharged.
TO INSTALL/REMOVE BATTERY PACK
See Figure 2, page 12.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
 Place the battery pack in the tool. Align the raised rib on
the battery pack with groove in the battery port.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
tool before beginning operation.
To remove:
 Depress the latches on both sides of the battery pack to
release the battery pack and remove it from the tool.
WARNING:
Improperly attached hoses or accessories can become
detached under pressure and cause serious injury.
Possible air leaks can cause faulty pressure readings.
Make sure all connections are tightly secured.
8 — English