MOUNTING THE CCT LIGHT
See Figures 6 - 7, page 9.
WARNING:
Only hang or mount CCT light in an area where no
electrical wires, utility cables, pipes, or other obstructions
are located. Contact your local utility company or a
qualified electrician if you are unsure. Do not hang light
from any electrical power cord. Ensure light is securely
installed to prevent falling object hazard. Failure to follow
these instructions can result in electrocution, electrical
shock, or other serious personal injury.
The light can be mounted to fit the application and work
environment. It may be used as a freestanding unit by placing
the light on its base on a flat surface.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
NOTE: ILLUSTRATIONS BEGIN ON PAGE 8 FOLLOWING
OPERATION
MAINTENANCE
FRENCH AND SPANISH LANGUAGE SECTIONS.
NOTE: Be careful not to mount or hang the light in such a
way that it prevents normal operation or damages the cord.
Mounting holes:
Hang or mount the light from a sturdy location using screws.
The mounting holes are designed for slide-mounting the
base of the light onto the screws. Center distance between
the holes is 2-1/2 in.
Tripod mount:
The light may be mounted onto a tripod using the 1/4-20
insert in the base plate of the light. Screw the tripod into the
hole on the base of the light.
NOTE: An adaptor is included with this product for
compatibility with HUSKY brand tripods.
NOTICE:
The LEDs cannot be replaced. Any attempt to replace
the LEDs may damage the light.
STORAGE
Store indoors in a dry, locked-up place, out of the reach of
children, with the battery pack removed and power cord
disconnected. Keep away from corrosive agents such as
garden chemicals and de-icing salts.
7 – English