Operating Instructions; Overview Of The Control Elements - brennenstuhl RUFUS 1500 MA Manual De Instrucciones

To remove dirt, a damp cloth can be used. Do not use any solvents, caustic cleaning agents, etc.
• Do not look directly at the light to avoid being blinded.
Hot surface
SET-UP/ MOUNTNG THE LAMP:
SET-UP/MOUNTNG THE LAMP
Using the multi-level, folding bracket, the tilt angle of the lamp can be adjusted as needed.
Using the multi-level, folding bracket, the tilt angle of the lamp can be adjusted as needed.
The lamp can be hung up on a hook using the bracket.
The lamp can be hung up on a hook using the bracket.
The lamp can be attached to metallic surfaces by means of the magnetic holder which, depending
The lamp can be attached to metallic surfaces by means of the magnetic holder which,
on the scope of delivery, is either included or available separately as an accessory. For this purpose,
depending on the scope of delivery, is either included or available separately as an accessory.
simply attach the magnetic holder to the bracket of the light. Please ensure that the magnetic
For this purpose, simply attach the magnetic holder to the bracket of the light. Please ensure that
holder is firmly seated in order to avoid possible damages caused by the falling light.
the magnetic holder is firmly seated in order to avoid possible damages caused by the falling light.
SWITCHING THE LAMP ON/OFF:
COMMISSIONING
Press the button (A) to switch the lamp on.
• Before using the device for the first time, completely discharge and recharge the rechargeable
The lamp will shine at 100% brightness.
battery once.
If the button is pressed again within 2 seconds,
• The product cannot be used during charging.
the lamp will switch to 50% mode.
• In cases of extended non-use, charge the battery every 3 months.
When selecting 50%, the service life of the lamp extends in
• The battery cannot be exchanged. If the battery is defective, the floodlight has to be disposed
comparison to the 100% setting as it consumes less energy.
of properly.
Press the button again to switch the lamp off.

OVERVIEW OF THE CONTROL ELEMENTS

Switch for power on/off and dimming:
Pressed once: The floodlight starts with the last light intensity set, the light intensity can
BATTERY LEVEL INDICATOR (B):
be adjusted in 5 steps by pressing several times.
Displays the current charging status of the battery, or, how much energy is still available.
If the switch is not actuated for more than 5 seconds, the floodlight switches off when it is
If all 4 LEDs are lit, the battery is fully charged. If the battery is nearly empty, the LED blinks
actuated again, regardless of the last brightness setting.
5 times and the battery status indicator blinks continuously. Then the lamp will remain lit for
approx. 5-10 minutes, before the deep discharge protection shuts the lamp off. This leaves
Switch to indicate the battery charge:
enough time to finish working.
When the floodlight is switched on, the battery charge is displayed in %.
When the floodlight is switched off, the battery charge can be displayed by pressing the
switch with the battery symbol. It is displayed until the switch is pressed again.
6
Switch for Bluetooth connection (RUFUS 3010 MA only):
When switched on, the floodlight changes to Bluetooth standby mode.
17P150_Akku_LED_Arbeitsstrahler_0496136_KW1219.indd 6
Switch for light colour (RUFUS 3020 MA only):
When the floodlight is switched on, it starts with the last light colour set.
The desired light colour can be set by pressing several times.
19P087_088 Mobiler Akku LED Akku Strahler Rufus 0532453_2320 200603.indd 9
1

Operating instructions

2
B
C
A
D
(similar to fig�)
D
3
16.03.19 13:12
9
03.06.2020 12:24:57